How long after algaecide Can you swim?

It is best to wait 30 minutes after adding it to your pool. We recommend waiting at least 15 minutes to swim after adding algaecide to your swimming pool. Most algaecides are perfectly safe to swim with. It is not recommended to swim with flocculent in your pool as it will reduce its effectiveness.
Takedown request   |   View complete answer on intheswim.com


How long after algaecide can you shock?

You should wait at least 24 hours before shocking the pool after adding algaecide. After shocking, always check the free chlorine and total chlorine levels because they could increase very high if you do not wait long enough before shocking.
Takedown request   |   View complete answer on aboutbackyard.com


Can you put too much algaecide in your pool?

Too much algaecide can cause foaming that can damage your filter. In some cases, too much algaecide can also cause eye and skin irritation. In addition to adding algaecide after shocking your pool, you should add algaecide to your pool water when closing down for the year.
Takedown request   |   View complete answer on poolcalculator.com


Should I run the filter after adding algaecide?

Add a dose of algaecide, bring your chlorine level high by shocking, and run the filter continuously until the problem clears. The next day you should vacuum up the dead algae and backwash your filter. Algae thrives in hot weather and in pools with low or no chlorine.
Takedown request   |   View complete answer on splashpoolsupply.com


Is algaecide harmful to humans?

Harmful if swallowed or absorbed through the skin. Avoid breathing vapor or spray mist. Avoid contact with skin, eyes or clothing. Prolonged or frequently repeated skin contact can cause allergic reaction in some individuals.
Takedown request   |   View complete answer on cdms.net


The TRUTH About Using ALGAECIDE In Your POOL | Swim University



Will algaecide help a cloudy pool?

5. Can I Use Algaecide to Clear Cloudy Pool Water? You can use an algaecide to kill early stages of green algae that might make your water appear cloudy, but the best method of getting rid of algae is to scrub and clean your pool using a large leaf net, vacuum, and kill algae with liquid chlorine shock.
Takedown request   |   View complete answer on dengarden.com


How much algaecide does it take to close a pool?

When closing and winterizing your pool, it is important to remember to balance your pool water's chemistry prior to closing and don't forget the algaecide. Algaecide is simple and effective with one quart of winter algaecide typically enough to treat 20,000 gallons of water all winter long.
Takedown request   |   View complete answer on theswimmingpoolstore.com


Do you run the pool pump when adding algaecide?

If chlorine is not enough in a green pool, it may easily turn even greener. To balance this effect you have to make sure that the level of chlorine is much higher right before the algaecide treatment. Leave the pool pump running to help the algaecide spread well within the water.
Takedown request   |   View complete answer on sundaysoffpools.com


Can I swim 12 hours after shocking pool?

Can I swim 12 hours after shocking the pool? It's usually safe to swim after letting the shock circulate in the water for at least 8 hours. However, we recommend testing the water's chlorine level before swimming. A high chlorine reading may be uncomfortable and dangerous to swimmers.
Takedown request   |   View complete answer on swimuniversity.com


Can I add algaecide during the day?

In addition to properly dosing your water, it is also recommended that the algaecide be added in the morning on a bright sunny day for best results. Algae are plants and grow in the presence of sunlight. Adding algaecide during algae's best growth time will increase intake of the algaecide and make it more effective.
Takedown request   |   View complete answer on poolspacare.com


Should I use shock or algaecide first?

While shocking and adding algaecide is effective in getting rid of algae, it should not be done together. This is because when you mix chlorine and algaecide together, it renders both of them useless. Hence, you should first shock the pool and wait for the chlorine levels to fall below 5 PPM.
Takedown request   |   View complete answer on richardstbs.com


How do I know if I put too much algaecide in my pool?

The presence of too much algaecide can lead to a foamy pool water. Small bubbles will begin to be produced as the water is pushed through the return jet and back into the pool. Do not confuse these bubbles and foam with another common problem, which is air in your pool lines.
Takedown request   |   View complete answer on hunker.com


What happens if you swim in a shocked pool?

What Happens If You Swim In A Shocked Pool? If you do not wait for the chemicals used to shock a pool to totally dissolve then you could be placing yourself in serious danger by swimming in it. At the minimum, you will feel itchy skin and eyes because of the chemicals present in the water.
Takedown request   |   View complete answer on triathlonbudgeting.com


How long should you wait to swim after shocking pool?

After you shock the pool — As soon as your chlorine levels reach 5 ppm or lower, it's officially safe to swim. Depending on the type of shock used, as well as the amount used, it can take anywhere from 24 hours or even up to a couple of days.
Takedown request   |   View complete answer on narellanpools.com


Why is my pool still green after shock and algaecide?

Pools can immediately turn green after shocking when they have metals like copper in the water. These metals oxidise when exposed to high levels of chlorine which makes the pool water turn green. Adding a metal control product such as Zodiac Metal Remover will help to restore the pool water.
Takedown request   |   View complete answer on zodiac.com.au


Can you swim the same day you shock a pool?

After Shocking Your Pool

It is safe to swim once your chlorine levels are around 5 ppm or after 24 hours. It is always best to test first!
Takedown request   |   View complete answer on intheswim.com


Can you swim in a cloudy pool after shocking?

Wait until the chlorine level in the water drops down to 1-4 parts per million (ppm) before allowing swimmers back into the pool. If the water still looks a little cloudy after the shock treatment, you may want to use a water clarifier before allowing swimmers back into the pool.
Takedown request   |   View complete answer on teampoolworks.com


Do you run filter when shocking pool?

Run the filtration system

While shocking your pool will help kill any germs any algae, it won't actually get rid of them; for that, you need your filter. So be sure to run your pool filter for at least 24 hours.
Takedown request   |   View complete answer on poolcareguy.com


Can algaecide turn pool green?

Many cheap algaecides contain copper which can turn your water, your hair green and stain your pool. The MSDS for this product shows that it is indeed 3.3% copper. You can treat this problem with routine additions of metal sequesterant or solve it with water replacement.
Takedown request   |   View complete answer on troublefreepool.com


Should I put algaecide in skimmer?

It is not advisable to pour algaecides into your skimmer.
Takedown request   |   View complete answer on myperfectpool.com.au


Does algaecide work in cold water?

One final note on algaecide: Contact algaecide is different from liquid algaecide. Many liquid algaecides don't work in cold water, and we don't recommend using them even in the warm months.
Takedown request   |   View complete answer on splashsupplyco.com


What happens if you close your pool with algae?

Closing a pool that is green with algae, or dirty with debris or with water that is unbalanced, leads to heavy staining and saturation of the water with dead algae cells, which makes it easier for subsequent generations to grow.
Takedown request   |   View complete answer on blog.intheswim.com
Previous question
Should I cover an infected wound?