Why does my well water smell like sewer?

If your cold well water smells like sewage, it can be the result of several causes: Hydrogen sulfide from iron, sulfur or other types of bacteria naturally occurring in your well water. Contaminated pipes with layers of bio-film caused by various types of iron, sulfur, or other types of bacteria.

How do you get rid of sewer smell in well water?

Pollution of well water from surface drainage

If the problem is in the well, shock chlorinate the well and pump out plenty of water until the smell of chlorine disappears. If the problem persists, consider installing: An activated carbon filter or. An automatic chlorinator followed by an activated carbon filter.

Why does my water smell like sewage?

Bacteria growing in the water heater: Bacteria growing in the water heater can also produce a rotten egg or sewage smell. Frequently, this occurs if the hot water is unused, if the water heater is turned off for a significant period of time or if the thermostat on the heater is set too low.

Why did my well water started stinking?

Certain “sulfur bacteria” in the groundwater, in the well water itself, or in the plumbing system can create this gas that smells bad. Chemical reactions inside water heaters can also produce sulfur bacteria. In rare cases, pollution can cause the gas to form. Sulfur bacteria are not harmful.

How do I get rid of the smell in my well?

Bad Smell in Well Water

Will Shocking well get rid of sulfur smell?

1. Shock your well with chlorine bleach or hydrogen peroxide to get temporary relief from sulfur odors. Often keeps odors away for 1 – 2 months.

How often should you shock your well?

Homeowners with private wells should have their well water tested every 3 to 5 years for some contaminants, including bacteria.

How do you fix sulfur smell in water?

Chlorine bleach can effectively remove medium to high levels (over 6 mg/l) of hydrogen sulfide. The chlorine in the bleach chemically reacts with (oxi- dizes) the hydrogen sulfide eliminating the "rotten egg" odor. Chlorine bleach also reacts with iron or manganese, and disinfects water supplies.

What type of filter removes sulfur smell from water?

The most effective way to treat and prevent sulfur from affecting you and your water is an iron filter. An iron filter can eliminate hydrogen sulfide in water as well as iron and manganese.

How do you remove hydrogen sulfide from well water?

Aeration. Since hydrogen sulfide occurs as a gas in water, it can be physically removed by injecting air into the water and allowing the gas to escape. Aeration units may work by cascading, bubbling, or stripping the gas from the water. Aeration may be advantageous because it does not add chemicals to the water.

Will a water softener remove sulfur smell?

It is better just to use a softener to soften the water and then have a separate system to remove the rotten egg odor, such as an Air Charger Sulfur Filter, or an Aeration Tank.

Why does my cold well water smell like rotten eggs?

Only cold water smells like sulfur: The major culprit behind cold water smelling like rotten eggs or sulfur is sulfate-reducing bacteria. Poor aeration and corrosion are often factors that increase the growth of this type of bacteria.

Is the smell of sewage harmful?

Answer: Only under extremely unusual circumstances. Although hydrogen sulfide is a toxic gas, it will not harm people at the concentrations that exist in a house with sewer gas odor problems. Studies have shown that hydrogen sulfide has a depressant effect on the central nervous system in concentrations above 150 ppm.

Is it safe to drink well water that smells like sulfur?

If the sulfur level in your drinking water is not too high, it shouldn't lead to any health issues. However, too much sulfate could lead to the following problems: Diarrhea and dehydration: Drinking water with a high sulfate content can have a laxative effect and lead to diarrhea, which can then cause dehydration.

How do I get the sulfur smell out of my house?

Baking soda is well known for erasing odours. And the best thing is that it's very easy to use and efficient too. If the smell is coming from your clothes then, soak them in baking soda before washing. You can also sprinkle baking soda in all the corners of your house to get rid of the sulphur scent.

How do you get sulfate out of well water?

How do I get the sulfur smell out of my sink?

If your drain smells like rotten eggs, you must disinfect the pipes to get rid of the odor. You can eliminate the bacteria by pouring a ½ cup of bleach down your drains. However, if you would like an alternative, pour down ½ a cup of baking soda and 1 cup of vinegar.

Why does my faucet smell like rotten eggs?

The reason your water probably smells like rotten eggs is because it contains some traces of hydrogen sulfide. Even extremely small amounts of hydrogen sulfide can cause your water to have quite the odorous smell! In most cases this smell occurs due to a build-up of hydrogen sulfide in your hot water heater.

How much does it cost to have a well Shocked?

How much does it cost to shock a well? If you hire a company to do it, it can cost anywhere around $100 depending on where you live. Doing it yourself will only cost as much as the chlorine, 10 gallon bucket and the safety supplies to do it.

Should I put bleach in my well?

You can disinfect your well with household chlorine bleach such as Clorox, Purex or a generic brand. The chlorine in the bleach kills bacteria. Note that it may take more than one chlorination for your well to return a satisfactory test.

How long after shocking well can you shower?

Do not shower for at least 24 hours after shocking your well. Waiting for one or two days more, if possible, is much better. Chlorine levels in the well water will go down only after freshwater dilutes and replaces chlorinated water. This process can take 1-2 days.

How much bleach is needed to shock a well?

Add 1 litre (1 quart) of household bleach for every 1.5 metres (5 feet) of depth of water. If you don't know how high the water stands, use the well casing depth to estimate how much household bleach to use.

How do I chlorinate my well?

Use ordinary liquid laundry bleach to shock chlorinate the water system. Determine how much bleach to use, then pour the bleach down the well and circulate it through the whole water distribution system. Wait 6-12 hours for the chlorine to work, then flush the chlorinated water from your well and pipes.

How do you aerate well water?

As water is forced through the venturi while the pressure tank is filling, air is sucked into the water line. The aerated water then enters a small treatment tank where the air is mixed thoroughly with the water and excess air is vented to the atmosphere.

Why does my bathroom smell like sewage at night?

A sewer gas smell in the bathroom can be caused by: evaporation of water in the P-trap piping. broken seal around the toilet in the wax ring or the caulk. A burst pipe.