When can I drive after PPF?

Don't drive your car the 1st week after installation (if possible). It reduces any chance of messing up the healing process. After the first week after installation, you can carry out more film maintenance practices discussed later.

How long does PPF take to cure?

Give PPF at least seven days to cure before washing the vehicle. If you are using a pressure washer, keep away from the film's edges. It could cause the edges to lift, reducing the protection. If you are planning to wipe the surface, make sure it's hydrated.

How long does Xpel PPF take to cure?

Yes, pressure washers can be used on XPEL paint protection films, provided the film has completely dried after installation (typically 48 hours) and provided the high-pressure water is not pointed directly at the edges of the film.

How do I take care of my car with PPF?

Can I wash my car after paint protection?

Do not wash your vehicle within 7 days of application. You need to give both Paint Protection Film and a Ceramic Coating time to fully cure on your vehicle. If you wash or otherwise agitate the surface, that can inhibit the curing process.

Paint Protection Film VS. Ceramic Coating Side-By-Side TEST | What's The Difference?

Can you drive after installing PPF?

The bubbles should not be pressed as this is part of the curing process and they'll dissipate within two to three weeks after installation. The moisture held in those bubbles evaporates through the film's pores. If possible, do not drive your car the first week after installation.

Can PPF be polished?

PPF can be polished much the same as your paint job. You might be wondering why polishing would be needed since its job is to protect the paint from scratches and chips. While that is indeed true, there are minor instances where the film itself doesn't need to be replaced – it just needs a bit of a refresh.

Which is better ceramic coating or PPF?

PPF provides better protection against damage caused by road debris and rock chips when compared with Ceramic coating. PPF has the ability to absorb the damage even before it touches the paint.

Are PPF worth it?

Yes, it can be. However, if your vehicle spends a lot of time exposed to the elements instead of inside a garage, the cost of paint protection film will be worth it when you see how much better your vehicle will look. Yet, full car PPF cost can vary. Pricing ranges from just a few hundred dollars to well over $7,000.

Will bubbles in PPF go away?

Air bubbles will evaporate over several days (or weeks, depending on weather) when the film is exposed to heat. If air bubbles are still on the film, the only way to remove it is to suck the air out with a needle. Expect these things to happen right after a PPF installation.

Does Xpel turn yellow?

Depending on which film you choose, you WILL notice a slight bit of yellowing no matter what brand. Out of the roll for example, XPEL is slightly yellower than Suntek. Hence why if a client is after the aesthetics, we recommend Suntek on lighter cars.

Can Xpel go through car wash?

Can I Run My Car Through An Automatic Car Wash? Yes, but please wait at least 48 hours after installation to allow the film to dry completely.

Does PPF stop stone chips?

Whilst a PPF won't stop a large stone from high speed damaging your vehicle, it will keep it protected from general stone chips and everyday wear and tear.

What should you not do after ceramic coating?

Use only recommended mild soaps. Avoid high volume brush style car washes, and high PH detergent style cleaners. Avoid washing in direct sunlight to minimize streaking and water spotting. Wash from the top down leaving the dirtiest sections for last to avoid cross contamination.

How often should you wash your car with ceramic coating?

This allows the coating to fully cure on your vehicle's surface. Once the 7 days have passed, we recommend that you clean your car at least twice a month to prevent contaminant build-up.

Can PPF be removed?

In order to safely remove PPF, you will need a heat source. A heat gun will work best, but you could also use a hairdryer or a steamer. The heat will soften the adhesive, enabling it to be safely removed. Start near the edge of the PPF and gently warm the surface.

Is there a downside to ceramic coating?

Disadvantages of the Procedure

Duration of the procedure (it may take much more time than waxing). Price (ceramic coating is an attribute of an expensive car. Not everyone can afford to apply ceramics). Difficult to remove (ceramic coating doesn't last forever.

Does PPF get swirl marks?

PPF is a proven solution for reducing the potential of swirl marks, light scratches, marring, and clear coat oxidation.

Which is better Xpel or 3M?

Self-Healing Properties

XPEL Clear Brand outperforms 3M when regarding self-healing properties. Even though 3M was the first company to enter the clear paint film industry, XPEL manufactured the first-ever self-healing film, which means that a scratched surface looks new shortly, even after a scratch.

How long does Xpel take to cure?

After installation, you may see a few water or gel bubbles under the film. This is normal and will go away once the film has fully cured (up to 45 days dependent on temperature and humidity).