What is the very first step you should take when starting your vehicle's engine?
Get in and Start the Engine
Make sure the parking brake is on. Put the gearshift in Neutral (or “Park” if automatic). Start engine and listen for unusual noises.
Which of the following are done before you start the engine?
Before you start your engine: Make sure all windows are clean. Remove anything that blocks your view of the road. Adjust the seat so you can reach all controls.What should you do before starting the engine quizlet?
What are the first two things you should do before starting the engine? Make sure the car is in park and the parking brake is set.Which of the following should be the first step when starting any car with an automatic transmission?
After starting the engine and shifting to proper gear. Which of the following should be the first step when starting any car with an automatic transmission? Set the parking brake.What steps would you follow to start a vehicle with an automatic transmission quizlet?
What steps do you follow to start a vehicle with an automatic transmission? Make sure the vehicle is in park, turn the key to start, release the key when the engine starts, and check gauges and warning lights before moving.5 Things To Do Before Starting Your Car-Driving Tips
When turning right on a road with multiple lanes into which lane should the driver enter when making and completing the turn?
If there are no signs or lane markings to control turning, you should turn from the lane that is closest to the direction you want to go, and turn into the lane closest to the one you came from. This way, you will cross the fewest lanes of traffic.When should you use one hand steering?
NHTSA recommends using one-hand steering only when turning while backing, or operating vehicle controls that require removing a hand from the steering wheel.What should you do before entering the roadway from a curb or side of the roadway?
Terms in this set (9)
- signal and check traffic to front, side and rear.
- identify a safe gap in traffic.
- look well ahead along intended path of travel.
- release brake and accelerate gently.
- steer into intended path of travel.
- cancel signal.
- check for motor vehicles and other highway users to the sides of the path of travel.
What to check before starting to drive?
The cockpit drill (often known as the DSSSM routine) consists of checking your doors, seat, steering, seatbelt and mirrors:
- Doors – check all doors are closed and secured before starting your engine.
- Seat and steering – adjust your seating so that the controls are within easy reach and you have a clear view of the road.
What to know before starting to drive?
6 Things You Should Know When Driving for the First Time
- Adjust the vehicle so that you are comfortable. ...
- Do not overthink the situation. ...
- Calm your nerves. ...
- Rid yourself of distractions. ...
- Stay on familiar roads the first time you drive. ...
- Stay away from interstates and major highways.
What are five habits you should develop when starting a vehicle engine?
What are five habits you should develop when starting a vehicle engine?
...
...
- Release the accelerator.
- Controlled or squeeze braking.
- Threshold braking.
- Trail braking or squeeze "off" braking.
Do you have to step on the brake to start a car?
Do You Have To Press The Brake When Starting A Car? It is good practice to press the foot brake before turning the key to start the engine. However, most models will allow you to start the engine without pressing the foot brake. An automatic transmission will start once the shifter is in “P” Park or “N” Neutral.How do you properly steer a car?
Proper Steering Wheel Hand Position
- Place both hands on the outside of the steering wheel on opposite sides.
- Maintain a firm-but-gentle grip on the wheel.
- Use your fingers to control the wheel rather than your palms. ...
- Don't turn the wheel when you're gripping it from the inside of its rim.
When should you use your horn?
Use your horn
- Only when necessary, to avoid collisions.
- To try to get “eye contact” with other drivers. You may tap your horn to alert another driver who might turn in front of you and cause a collision.
- On narrow mountain roads, where you cannot see at least 200 feet ahead of your vehicle.
What is the first thing to do when you make a three point turn?
To make a three-point turn:
- Move as far right as possible, check traffic, and signal a left turn.
- Turn the steering wheel sharply to the left and move forward slowly. ...
- Shift to reverse, turn your wheels sharply to the right, check traffic, and back your vehicle to the right curb, or edge of roadway.
When you change lanes or merge into another lane you?
When you change lanes, or merge with another lane, you:
- Have the right of way.
- Should first stop and check for cross traffic.
- Need at least a four second gap in traffic.
What is the first thing you should do when planning to make a two point turn?
Step 1: Slide into a DrivewayTo change direction by making a two-point turn, you'll need to use either a driveway or a cross street. Check for traffic and slow down as you get ready to turn. Next, pull slowly into the driveway or street, turning the steering wheel as needed.
What are the basic steps to start a vehicle quizlet?
Terms in this set (13)
- Unlock the vehicle and climb into the driver's seat.
- Adjust the mirrors so you can see behind the vehicle clearly, and identify the car's blind spots before you start driving.
- Identify the controls. ...
- Place your right foot on the brake pedal and push it down, insert the key and start the vehicle.
When starting a vehicle the gear selector should be in?
at least 3-4 seconds. In most cases, when starting a vehicle, the gear selector should be in ? 1 foot on the brake and the other on the "dead pedal." what is immediately in front of his/her vehicle, behind his/her vehicle, and is 10-15 seconds ahead of his/her vehicle.What are the four steps in the IPDE process?
The four steps of the IPDE process are:
- I—Identify—Locate potential hazards within the driving scene.
- P—Predict—Judge where the possible points of conflict may occur.
- D—Decide—Determine what action to take, when, and where to take it.
- E—Execute—Act by maneuvering the car to avoid conflicts.
What are the 8 steps of driving?
Terms in this set (8)
- I want to drive (permit, walk around, cell phone off, keys)
- I want to be secure in my seat (put on seat belt, check passengers)
- I want to be in position to control the car and then be able to see (adjust seat then mirrors)
- I want to be safe in the car (lock doors)
← Previous question
How old is narrator VR?
How old is narrator VR?
Next question →
What is the history of HCI?
What is the history of HCI?