What is MTA obturation?

MTA canal obturation offers an innovative method to approach challenging endodontically involved teeth that may not respond using traditional filling materials and sealers when extensive pathosis is present.

Can MTA be used for obturation?

Using MTA as the filling material in uncomplicated root canals is an acceptable treatment option for conventional obturation, patients with holistic treatment concerns and cases with extensive pathosis.

What is MTA in endodontics?

The mineral trioxide aggregate (MTA) is a dental material with biocompatibility properties to oral and dental tissues. MTA was developed for dental root repair in endodontic treatment and it is formulated from commercial Portland cement, combined with bismuth oxide powder for radiopacity.

How do you put a MTA on a root canal?

The MTA powder is mixed with sterile water, and the mixture is placed in contact with the exposure using a Dovgan carrier (Figure 2). Compress the mixture against the exposure site with a moist cotton pellet. Place a moist cotton pellet over the MTA and fill the rest of the cavity with a temporary filling material.

Is MTA a sealer?

MTA could be used as a root canal sealer with equal effectiveness compared with epoxy resin and zinc oxide eugenol sealers.

MTA Endodontics - Obturating a Canal w/ MTA

Is MTA a liner or a base?

MTA provides a higher incidence and faster rate of reparative dentin formation without the pulpal inflammation. MTA Plus material is also indicated for base and liner in vital pulp therapy. In root-end filling after apicoectomy, the anti-washout agent (chitosan or gelatin) is useful to prevent from MTA washout.

Can MTA be used for pulp capping?

MTA is a new and biocompatible biomaterial used for dental practice. It has been proved to be an excellent material for repairing of root perforations, apexification, root-end filling, repairing of root resorption and pulp capping.

What are the advantages of MTA?

MTA has the advantage of being less soluble than calcium hydroxide and offers an enhanced seal due to its setting expansion which hermetically seals the pulp space, preventing bacterial contamination from the outside.

How long does MTA take to set?

It has been reported that MTA sets slowly approximately 3-4 hours in clinical conditions (3, 25). Long setting time of MTA can cause clinical problems.

What is the main component of MTA?

Mineral trioxide aggregate (MTA) is composed of Portland cement, with 4:1 addition of bismuth oxide added so that the material can be detected on a radiograph. The cement is made up of calcium, silicon and aluminium. The main constituent phases are tricalcium and dicalcium silicate and tricalcium aluminate.

What is the difference between MTA and calcium hydroxide?

MTA is more effective and superior comparing the Calcium Hydroxide as a direct pulp capping material, showed higher success rate with favorable outcomes in maintaining long term tooth vitality and easier to use in pulp capping. MTA is less toxic, less pulpal inflammation capping compared to Calcium Hydroxide.

What is MTA pulpotomy?

MTA may be used as an alternative pulpotomy agent in immature teeth with pulp exposure to stimulate pulp healing with dentin bridge formation and complete root formation. But, discoloration following MTA pulpotomy appears as a major clinical complication.

What is the pH of set MTA?

pH. Hydrated MTA has an initial pH of 10.2, which rises to 12.5 (similar to calcium hydroxide) 3 hours after mixing and following setting. The high pH is theorized to be responsible for the antimicrobial action and biological activity of the material.

How do you remove the MTA from a root canal?

Removal of MTA from dentin by applying 37% hydrochloric acid (HCl) to reduce microhardness and push-out bond strength.

Can MTA be mixed with saline?

The high sealing ability of MTA in combination with normal saline has been supported by all these studies. Also our study proved the superiority of the combination of MTA with normal saline compared to 5% CaCl₂ and KY Jelly.

Is MTA used in primary teeth?

MTA as a pulpotomy agent has shown favorable results in case of primary molars. There is limited literature available regarding its use in primary incisors. However, the success of vital pulp therapy with MTA depends on proper case selection and technique of management of the tooth than the material itself.

Why do we use calcium hydroxide in direct pulp capping?

Calcium Hydroxide Cavity Liners

Calcium hydroxide cements are used for lining specific areas of deep cavities or for direct pulp capping. The antibacterial action of calcium hydroxide makes these cements useful in indirect pulp-capping procedures involving carious dentin.

What material is used for pulp capping?

Two types of pulp-capping materials, calcium hydroxide and mineral trioxide aggregate, have been most commonly used in clinics, and an adhesive resin has been considered a promising capping material.

What does MTA do to pulp?

The researchers have reported that MTA induces proliferation of pulp cells,41, 42 it stimulates osteoblasts to release interleukins⁴ with formation of hard tissue,⁴³ and an interface with the dentin that is very similar in composition to the hydroxyapatite.

What is MTA pulp therapy?

MTA was used as pulp-capping material after partial pulpotomy to preserve the vitality of the pulpal tissues in two cases. Follow-up examinations revealed that the treatment was successful in preserving pulpal vitality and continued development of the tooth.

Is MTA a calcium silicate?

Mineral trioxide aggregate (MTA) is a calcium silicate-based cement (CSC) commonly used in endodontic procedures involving pulpal regeneration and hard tissue repair, such as pulp capping, pulpotomy, apexogenesis, apexification, perforation repair, and root-end filling.

Is MTA calcium hydroxide?

Interestingly, the primary reaction product of MTA with water is Calcium Hydroxide, and so it is actually the formation of calcium hydroxide that provides MTA's biocompatibility [10,24- 27] As a result, many of the advantages and potential mechanisms of action for MTA are similar to Calcium Hydroxide, including its ...