What is minimum throttle?

min throttle gets set about 25-50 above where all motors start spinning. you dont want your motors to come to a stop in air when you drop the throttle to zero. quad will not liftoff when armed. if it does, min throttle is set way to high.

How do you set throttle in Betaflight?

Go to Mixer, find the Throttle channel, hold down the Enter button and select Edit. The default value for Weight is 100, which means 100%. Reduce it to whatever percentage you like. You will notice the bar on the right shrinks on both sides as you reduce Weight.

What is min throttle Betaflight?

-min throttle = the minimum value sent to the FC when throttle is all the way down (but does this effect idle speed at all?) -idle speed = the % of total throttle range (1000 to 2000 so that's 1000 therefore 5% would be 50, thus 1050 value sent to FC, correct?) Thanks in advance!

What should engine idle throttle value in Betaflight?

High authority quads often fly best with idle values around 4-4.5%.

What is throttle mid Betaflight?

Throttle Mid and Expo

Throttle Expo changes the shape of the throttle curve, it flattens out the curve around “Throttle Mid” and allows for softer throttle response and maximum stick resolution around this throttle level. Throttle Mid changes where in the throttle curve you want to apply the Throttle Expo.

Where is INAV min_throttle? INAV 2.4 changed this and that...

What is anti gravity in Betaflight?

Anti_gravity basically multiplies the I gain by a certain number(the default is 2 or so, but you can change that) the moment throttle changes very quickly, and it immediately reduces it once the quadcopter has maintained the attitude correctly so it doesn't then spiral out.

What is throttle drone?

Throttle gives the propellers on your drone enough power to get airborne. When flying, you will have the throttle engaged constantly. To engage the throttle, push the left stick forward. To disengage, pull it backwards.

What is Expo on RC transmitter?

Exponential rate is where the servo movement is not directly proportional to the amount of control stick movement on your transmitter. Over the first half on the stick travel, the servo moves less than the stick. This makes control response milder and smoothes out level flight and normal flight maneuvers.

What is PID tuning drone?

PID controller are often used for controlling a drone. This is a program in the drone, which evaluates the sensor data and drives the motors accordingly via motor controller. PID stands for: proportional–integral–derivative and will be explained later.

Is flying a drone hard?

What is this? Drone flying is actually fairly difficult, especially for a beginner with no practical background in flying anything remote-controlled. This is why many beginners take flying courses or start with flight simulation software. It is always best to know the basics first before actually flying a drone.

What is yaw in drone?

Imagine three lines running through an airplane and intersecting at right angles at the airplane's center of gravity. Rotation around the front-to-back axis is called roll. Rotation around the side-to-side axis is called pitch. Rotation around the vertical axis is called yaw.

How can I fly my drone with my phone?

You can connect your drone to an Android phone by:

Go to Settings > Network and Internet > WiFi. Connect to your drone's WiFi network using the passphrase included in your manual. You can use the mobile app to complete all setup, calibration, and configuration steps. Get to Flying!

What is paralyze mode in Betaflight?

Paralyze. Designed for racing. When activated it shuts down VTX and RX to avoid interfering with other pilots who might be still flying. It can only be reset by unplugging the battery.

What is Angle mode in drones?

Angle mode is a self-level mode that has to do with the tilt of your drone. Here, you need to learn how to properly move your roll/pitch stick to its top position.

How does Prop walk work?

Propeller walk is caused by the water, moved by the propeller in an axial direction and in a rotation. The water, coming from the propeller, gets a cone shape, widening when it leaves the propeller. If the rotating water cone contacts the ship's hull, a sideways force is generated.