What does NS mean in lift?

Note that the panel also includes the Non-Stop (NS) button. 1980s Toshiba elevator attendant switches.

What does S stands for in elevator?

b) The 'S' stands for “service.” When maintenance workers need to hold an elevator at a floor, pressing and holding this button for several seconds will take the elevator out of circulation for a pre-programmed amount of time—usually five minutes, or until a floor is selected.

What is SB in elevator?

SB Elevator Abbreviation. 1. SB. Sub-Basement. Floor, Building, Drawing.

What does C stand for in lift?

The C stands for Concourse which is the open area inside the metro station which has the ticket counter, check in/out and elevators & staircases leading up/down to the platform. 19. Related questions (More answers below)

What is b1 in lift?

"B" is "Basement", the floor below the ground.

Pressing the Stop button in the lift ??

What is M in lift?

M or MZ is commonly known as mezzanine floor, which is an intermediate floor between main floors of a building.

What does RC mean in elevator?

In American English, "ground floor" and "first floor" are generally synonymous and thus can both be used for rez-de-chaussée. So when you're in a French elevator, instead of seeing a button marked "G" for "ground floor," you'll see one marked "RC" for rez-de-chaussée.

What does DH mean in an elevator?

This button is especially common in freight and bed/hospital elevators. Door hold button is normally identified as Extend Open, Open Hold, DH or simply Door Hold or Hold.

Why is there no number 4 in elevators?

In many East Asian cultures, including China, Korea, Japan and Taiwan, the number 4 is considered unlucky. If you step onto an elevator, you probably won't see a button indicating the fourth floor because most apartment buildings and hospitals skip the number altogether.

Why do lifts have 2 buttons?

Two Call Buttons are used outside the Elevator to determine which Direction you'll be going and to avoid the elevator reach maximum capacity by putting request calls on HOLD by preventing to halt on floors where the person wants to travel an opposite direction.

What is M floor?

A mezzanine floor is an intermediate floor between main floors of a building, and therefore typically not counted among the overall floors of a building. Often, a mezzanine is low-ceilinged and projects in the form of a balcony.

What is UG floor?

English translation: first floor / first basement floor (level)

What is a 2 stop elevator?

Provides easy access for the physically challenged. Safer and more comfortable than other modes of transporting up and down stairways. Reliable and durable. 750 lb capacity.

What is the real name of the R type elevator?

Description. GPQ elevator is a machine room less elevator designed for residential and commercial buildings. It consists of two models; one is the R-type for residential buildings and the second is the P-type for commercial buildings.

Why there is no 13th floor in lift?

It is easier to sell six units than an entire tower numbered 13." Otis Elevators says that close to 85% of the buildings with elevators do not have a floor numbered 13. Several building designers, bowing before the tenants' superstitions, omit listing a 13th floor on their elevator panels.

Is number 4 Banned in China?

In Mainland China

The Chinese avoid phone numbers and addresses with fours because the pronunciation in "four" and "death" differ only in tone, especially when a combination with another number sounds similar to undesirable expressions. Example: “94” could be interpreted as being dead for a long time.

Why there is no room 13 in hotels?

Some hotels skip the number 13 and go straight to 14 when numbering floors. This is true for other tall buildings as well. It is because of the disorder triskaidekaphobia and a general dislike of or superstition regarding the number 13.

What does HC mean in construction?

HBIM - Historic Building Information Modelling. HBN - Health Building Notes. HC - hydrocarbons.

Is ground floor 0 or 1?

The floor at ground or street level is called the "ground floor" (i.e. it needs no number; the floor below it is called "basement", and the floor above it is called "first") in many regions.

What is the meaning of Rez de Chaussée?

Definition of rez-de-chaussée

: the ground story of a building whether on a level with the street or slightly above it —used especially of a building on the continent of Europe.

What does the star mean in an elevator?

The star is for visually impaired people, and it should take you to the floor with an emergency exit. Usually the lobby or first floor. It's a requirement in some areas. Normally they just put the star on the ground floor button, but sometimes the elevator button design doesn't allow labels, such as this one.

How do you use an NS lift button?

On some older Otis and Schindler elevators from the 1960s to 1980s (or the buttons are using generic fixtures), the button is usually marked as "NS" and it is normally located below the floor buttons. Up: Switch the elevator to up direction. Down: Switch the elevator to down direction.

Is it illegal to make a small talk in an elevator in NY?

It is against the law in New York State to speak to anyone in an elevator. In addition, elevator passengers should fold their hands while looking toward the door. In New York State it is illegal to greet another person by “putting one's thumb to the nose and wiggling the fingers."

What do you call elevator buttons?

Call Buttons are used to request an elevator. They are mounted 42" above the finished floor and consist of an up button and a down button that illuminate to indicate the request has been received and an elevator is on the way.