Should drywall touch the ceiling?

The ceiling should always be installed first in areas with a drywall ceiling. The wall sheets at the ceiling angles butt up flush against each other due to this method of hanging them before the walls. This primarily tightens and simplifies the junction points at the tops of ceilings.

Do you leave a gap between drywall and ceiling?

Cut it to leave about a 1/8-in. gap at edges (right). In fact, when you're hanging the ceiling, keep in mind that 1/2 in. along the perimeter will be covered by drywall on the walls.

Should drywall go all the way to the floor?

Always leave a 1/2-inch gap at the floor. This allows for floor and wall expansion without cracking the drywall. It also helps prevents moisture wicking if the floor floods. Wear work gloves, safety goggles and a dust mask when hanging drywall.

How high off the floor should drywall be?

3 Answers. Show activity on this post. Drywall should definitely not touch concrete as moisture will wick (ie flow up the surface as in a candle/lamp wick) into the drywall and encourage mold growth. 3/8" should be sufficient - your prop up plan is not only appropriate, but a common technique used by drywallers.

How do you fill the gap between drywall and ceiling?

Hang Drywall on the Ceiling the Right Way

How big of a drywall gap is too big?

Another situation that calls for filling is a drywall gap between sheets that's more than about 1/2 inch wide. If you tape over a wide gap like this without filling it first, the tape will flex, and the joint compound covering it will chip away.

Why is there a gap between wall and ceiling?

Gaps between your walls are often caused by a home's foundation settling into poorly compacted, moisture-softened, or shrunken soils below the structure. Few issues can make a homeowner's heart drop quite like noticing a gap between the walls and floor (or ceiling) of a property.

When hanging drywall do you hang the ceiling first?

Hanging Drywall From the Top Down

Hang drywall on the ceiling first, then the walls. Check the ceiling for bowed joists using a 4-ft. level. Irregularities less than 1/8 in.

Is it OK to drywall walls before ceiling?

Yes, you should install drywall on the ceiling before the walls for multiple reasons: The drywall on the walls can support the ceiling pieces. You can create tight and fitted corners more easily. The pieces are easier and faster to work with from the top.

Does it matter if you drywall ceiling or walls first?

When hanging drywall, always hang the ceiling first. This is the hardest drywall to hang, so get a partner and go slow. Large cracks due to misaligned sheets are hard to repair because the extra mud required to fill them will constantly fall out and drop to the floor (or worse, down the back of your neck!).

Should there be a gap between drywall sheets?

However, during installation, be diligent about keeping that 1/8 inch space between sheets by using a guide. The blade of a drywall square is about 1/8-inch-thick and does the trick. Thin strips of wood can also be used as spacing guides.

Can drywall be stored on edge?

You can lean drywall vertically on its side if you plan on leaving it that way only for a few days or weeks, but for more long-term storage, you should try to store Sheetrock by stacking it flat.

What are two common mistakes made during Drywalling?

Should I caulk between wall and ceiling?

Method #1: Using Caulk

This method is the most time consuming, but it creates a very crisp, even line where the ceiling and wall meet. It's the best way to touch up an already-painted room.

Do you stagger drywall seams on ceiling?

It's not necessary to stagger seams on ceiling drywall. However, because these joints are relatively difficult to finish – and tend to be noticeable in the finished product – it's a good idea to stagger the drywall panels to make the joints less visible.

Why do you hang drywall horizontally?

Horizontal hanging reduces the lineal footage of seams by about 25%. Keeping the footage of seams to a minimum will result in less taping and a better looking finished job. Hanging horizontally also allows the drywall to flow over the framing so that bowed studs create less of a problem.

Why do you stagger drywall?

Ultimately, staggered seams are stronger because the joints – the weakest part of the wall or ceiling installation – are minimized. Staggered joints are also less visible and easier to conceal for a flawless finish, offering a smoother, more professional look to the completed job.

Where does the wall meet the ceiling?

"Edge" would have been a much better word to use in asking because of the reduced ambiguity. To be most clear, the reason I accepted the answer is because of the word crown. Crown can be used to distinguish the difference between the edges where the walls meet the ceiling vs where the walls meet the floor.

How big a gap can I fill with drywall mud?

Setting-type compound (the bagged kind you mix vs. the drying-type you buy premixed in a bucket) will easily fill a 1/2" gap without cracking. Make sure you load up the gap well before applying your tape, then finish it as you would any other joint.