How often do you need to change coolant fluid?

As a general rule of thumb, you should get a coolant flush every 30,000 miles or three to five years, whichever comes first. Your car's owner's manual should also outline a more specific interval depending on the manufacturer.

How often should you change coolant fluid?

HOW OFTEN SHOULD YOU FLUSH THE COOLANT? Depending on the vehicle and the coolant, the average time between flushes is two years or 30,000 miles for silicated coolants and up to five years or 100,000 miles for an extended drain coolant. You can tell which type of coolant you have by the color.

Is changing coolant fluid necessary?

The simplest way to avoid overheating is to service the system every two years or according to your car manual recommendations. Flushing the coolant and replacing it with fresh fluid every two years or 30,000 miles is a good rule.

What happens if you dont change coolant?

The coolant can become more acidic over time and lose its rust-inhibiting properties, causing corrosion. Corrosion can damage the radiator, water pump, thermostat, radiator cap, hoses and other parts of the cooling system, as well as to the vehicle heater system. And that can cause a car engine to overheat.

How much should a coolant flush cost?

The average cost to flush coolant from a radiator is anywhere from $100 to $200. The exact cost will usually depend on where you go (an independent mechanic will be cheaper than a dealership). Some less reputable shops might only charge between $50 and $100.

Tip of The Week: When to Change Coolant

How do I know if I need a coolant flush?

Vehicle Overheating and High Temperature Gauge

The primary role that coolant plays in your vehicle's functioning is keeping your engine temperatures low. If you find that your temperature gauge is always high and your engine is frequently overheating, chances are that you need a coolant flush.

Is coolant the same as antifreeze?

Engine coolant, also known as antifreeze, is mixed with water to keep the radiator from freezing in extreme cold and overheating in extreme heat. There are many different types of coolant, so it's important to know what variety is right for your car or truck.

Does coolant go bad?

A sealed bottle of antifreeze has an indefinite shelf life. Once opened, it will keep for years if stored in the original container. Antifreeze – coolant that has not been mixed with water – tends to last even longer than pre-mixed engine coolant, though both last for years.

Can a coolant flush damage your engine?

Getting a coolant flush will prevent the old anti-freeze from becoming acidic. This is important because once it starts to become acidic it will break down and can damage the bearing in the water pump, the rubber hoses and the aluminum components of the engine.

Does coolant flush help AC?

Your A/C system uses a type of refrigerant (commonly called Freon) to cool the interior of your vehicle. Having a coolant flush performed will not help your A/C stay cool, or visa versa.

Does a coolant flush clean the heater core?

After they will drain the system once more. Then they will wash out the area near the water pump, where there are a lot of little seals that, if cracked, can cause leaks and add even more debris to your cooling system. After another drain, your mechanic will wash out the heater core.

What does dirty coolant look like?

Coolant that is still doing its job to protect your engine can be any variety of colors from green to red to orange, but the key is that it will be translucent. When it's past its prime, it will become a brownish color and more opaque. If it's in really bad shape, it will be a sludgy brown.

What color should antifreeze be?

Fresh antifreeze is a clear brightly coloured liquid, usually blue, red, green, violet, yellow or orange but this will vary depending on the manufacturer's formulation. Over time, your coolant will become dirty losing its colour and becoming darker, often an oxidized shade of brown.

What do different colors of coolant mean?

If antifreeze is green, that probably means it was made from an older formula that uses something called Inorganic Additive Technology. Green antifreeze is made with special tweaks to the formula specifically to help prevent the corrosion of metals in a vehicle's cooling system.

How does Jiffy Lube do a coolant flush?

COOLING SYSTEM FLUSH AND FILL

A Jiffy Lube® coolant service starts with an examination of your radiator and engine cooling system. Then, old antifreeze/coolant is removed from your radiator and replaced with new antifreeze/coolant per your vehicle manufacturer's recommendations.

Can I just add coolant to my car?

If the coolant level is low, add the correct coolant to the reservoir (not the radiator itself). You can use diluted coolant by itself, or a 50/50 mixture of concentrated coolant and distilled water. When the coolant rises to the cold fill line, replace the cap and tighten it until you feel it click. Close the hood.

Can you do a coolant flush at home?

Remove the radiator cap and pour distilled water into the radiator until full. Replace the cap, then start up the vehicle and let it run for 10 to 15 minutes. This will work the distilled water into the engine, flushing out any loose debris or corrosion along with the last of the old antifreeze.

Can I just top off coolant?

Top off the coolant reservoir

If the coolant level is low in the reservoir, you can refill it to the max fill line but do not overfill it. The coolant mixture expands when it heats up and needs the extra room. Keeping your coolant at the correct level is one of the ways to keep your radiator good working order.

Can I use water instead of coolant?

Water by itself can't do the job of antifreeze due to its lack of boiling and freezing point range and its inability to protect your vehicle's engine. Plus, it doesn't absorb heat as effectively. In the case of an absolute emergency, you can use water in your coolant rank.

Why is my coolant dark orange?

A rusty color indicates that the rust inhibitor in the coolant has broken down and it can no longer control rust and scale buildup. The system must be cleaned/flushed and a fresh 50/50 mix of coolant installed to restore integrity.

Does the color of coolant matter?

The truth is, color is not a reliable predictor for what type of coolant you have.

How long does a coolant flush take?

A trained mechanic can perform a radiator flush in about 30 minutes using a commercial coolant flush and fill machine. Without a machine, a radiator flush takes about two hours. You'll need to allow additional time for any other services performed at the same time, such as radiator leak repair or inspection.

How much is a radiator flush at Jiffy Lube?

Cost of the coolant flush in Jiffy Lube

The radiator fluid costs around $99.99 with full diagnosis. The specialized technical team will do a thorough check and will guide you regarding what to do and what not to.

How much does it cost to flush heater core?

Usually, repair shops will use a dedicated flush machine to flush the entire cooling system, rather than flushing just the heater core with a garden hose. You can expect to pay somewhere between $100 and $250 for this service.

What happens after a coolant flush?

A flush will rinse these out, for optimum performance. Lubrication: Replacing tired coolant/antifreeze with a new batch will lubricate moving parts in the cooling system, such as the water pump. This will extend the life of key components in the system.