How much is it to replace a pulley?

Idler Pulley Replacement Cost

The cost to replace the idler pulley of your driver belt will usually be somewhere between $80 and $200. The cost for the new part should only be anywhere from $40 to $90, while the cost of the labor will be anywhere from $40 to $110.

How much does it cost to replace a serpentine belt pulley?

A typical serpentine belt start at around $25 and goes up to $75 at most. If you know some car repair basics, you could change the belt yourself, and it may save you paying labor charges somewhere between $75 and $120. All together, you're looking at around $100 to $195 to replace your serpentine belt.

How much does it cost to replace belt pulley in car?

The average cost for a drive belt tensioner replacement is between $211 and $239. Labor costs are between $73 and $93, while parts are priced between $138 and $146. Taxes and fees are not included in the estimate.

When should a pulley be replaced?

An idler pulley is expected to wear over time, and eventually the pulley will fail. Replacement intervals for idler pulleys vary, but are usually within the 50,000 to 100,000 mile range. Replacement often coincides with expected serpentine/accessory belt replacement periods.

How long does it take to change a pulley?

If you are doing the job at home, give yourself about four hours to change all the parts. You will need the following tools and parts: Replacement idler pulley.

Idler Pulley, How to replace (EASY and CHEAP)

What happens if a pulley breaks?

A broken or seized pulley can quickly lead to a torn belt, or in less serious cases, the belt falling off of the engine. An engine without a belt can quickly run into issues such as overheating and stalling, as it's the drive belt that allows the engine accessories to function.

What causes a pulley to break?

Improper Tension

If a belt is not tensioned properly, it will ride too loose or too tight on the pulley. A belt that's too loose on a pulley will cause slippage, which leads to heat build up from friction. This heat will damage your rubber belts and cause the belts to crack and break.

How do I know if my pulley is bad?

What does a pulley do on a car?

Its primary function is to provide tension and guide the engine drive belt. These belts wrap around the various parts of the engine such as the power steering pump, alternator, water pump etc... To keep it simple, idlers are complementary pulleys that make the entire system run smoothly.

What happens if a serpentine belt breaks while driving?

If a serpentine belt breaks, a car won't be drivable and will have to be towed. If the engine runs without a serpentine belt, it might overheat as the water pump will no longer work. A broken belt can also damage other parts.

How much does a mechanic charge for a serpentine belt?

But what does a serpentine belt replacement cost? Of course, it depends on your make and model as well as labor costs, but in general a replacement serpentine belt costs around $70-$200 (plus taxes and fees), including around $50 for the belt and around $150 for the labor.

Can you drive without serpentine belt?

Under no circumstances can you drive a vehicle without a serpentine belt because the serpentine belt serves the important function of delivering antifreeze to important parts of the engine. The serpentine belt drives the water pump, and without it, there is insufficient coolant flow to maintain the engine temperature.

How much does it cost to replace idler pulley?

Idler Pulley Replacement Cost

The cost to replace the idler pulley of your driver belt will usually be somewhere between $80 and $200. The cost for the new part should only be anywhere from $40 to $90, while the cost of the labor will be anywhere from $40 to $110.

Can I drive with bad pulley?

Idler pulleys are a completely different story. In some cases, you will be able to safely drive for tens of thousands of miles before you notice any drops in performance. But, it takes only one slip of the belt for the engine to lose momentum and for you to lose control over the vehicle.

Can you drive with a bad tensioner pulley?

Driving with a bad belt tensioner is unsafe since the tensioner is meant to guarantee ample tension that powers accessories. Wear on the belt tensioner will eventually cause the belt to slip, generate loud noise, and also create an unsafe level of heat along the accessory pulleys.

What is an engine pulley?

An engine pulley is a wheel mounted to the engine of an automobile or other vehicle that guides or drives a belt, sometimes known as a serpentine belt. This belt is part of a system that powers peripheral devices within the engine compartment, such as the air conditioner, power steering, and fan of the vehicle.

What happens when crank pulley fails?

The most common symptoms of a failing crankshaft pulley are loss of or change in engine performance, knocking and vibrations coming from the engine bay, or tapping sounds while the car is idling or under load.

Are pulleys covered under warranty?

The idler pulley is literally the only part ON THE ENGINE that isn't covered under the Powertrain warranty. Sure it may have needed to be replaced at some point but it didn't fix the sound I brought it in for, that idler puller was causing me no problems.

Why is my car making a whining noise when accelerating?

While the transmission is the most likely cause, whining while accelerating can also be caused by low power steering fluid or more serious damage like faulty alternator bearings, a malfunctioning water pump, a broken piston or a bad AC compressor.