How much does it cost to install a pole?

VERY rough numbers - commonly about $5-10/LF for overhead runs (meaning new poles typically every 100-300 feet, possibly more in high tree area), plus $500-3000 per pole needed depending on length (probably about 36-40' tall minimum for your area if not rural but can be much more in heavily treed areas, so closer to ...

How much does it cost to install a light pole?

A street light pole is far more expensive than a consumer light pole. The average street light pole cost ranges from $2,000 to $3,000, not including installation. The installation cost depends on the city, but the average is somewhere around $1,000.

How long does it take to install a power pole?

How long does it take to replace a pole? Estimates vary greatly depending on the location and complexity of the replacement. General estimates range from 8 to 18 worker hours for a low-difficulty replacement and 20 to 75 worker hours for a high-difficulty replacement.

How much does a 40 foot telephone pole weigh?

The average steel distribution pole (40 foot, Class 4) weighs approximately 450 pounds, and is at least 30 percent lighter than a wood pole.

How much does a new telephone pole cost?

With an average installed cost per pole of $3000, the total installed cost is $63 million per 1000 miles. Typically around 12% of these poles are inspected every ten years at an inspection cost of approximately $100 per pole using third-party inspectors.

Buying a Pole Dancing Pole for home - WHAT YOU NEED TO KNOW!

How heavy is a 35 foot telephone pole?

Approximate weight: 643 lbs.

How deep will a power pole go?

Depth – Power-Pole has a maximum deployment of 10ft deep for the most effective stopping and holding vs. 12ft.

How deep are telephone poles underground?

The typical utility pole runs about 40 feet in length, of which 6 feet is buried in the ground. In urban environments they are commonly spaced about 125 feet apart, while in rural areas the distance is more like 300 feet.

Which is better power pole or Talon?

– The Short Answer. A Power Pole is best for saltwater use by boaters who don't have limited space within their boat. A Minn Kota Talon is best for freshwater use by boaters who have limited space or want to easily remove the unit to use on another boat. Overall, Power Pole is usually the best overall choice.

How much does it cost to install an outdoor light post?

Professional contractors charge an average of $970 to install a lamp post and require about 13 hours of labor. Most of this cost is labor, so location is the primary cost factor. The cost also increases the further the lamppost is from the house, especially when the power lines are underground.

How deep does a light pole need to be?

Calculating the Depth of the Pole

Poles are typically set into the ground: 10% of the overall height + 2 feet, except in questionable soil conditions. Example: Overall pole height: 30 feet, the pole should be buried: 3 feet + 2 feet = 5 feet below grade, and 25 feet above grade.

How do you install an outdoor light pole?

How much do concrete poles cost?

The estimated cost of concrete pole replacements is $4,000 each, plus installation estimated at $4,000 to $5,000 each pole.

How long does a utility pole last?

Many utility poles are several decades old

Most power poles are much older than their useful life expectancy, which is likely somewhere around 50 to 60 years. But some of them are much older. Metal and concrete poles can last much longer than wood, but eventually all utility poles need to be replaced.

Who owns electric pole?

The power lines between the power pole and your home, are owned by you (the homeowner). This means that if there is any problem with the power line between the power pole and your property, you will be responsible for their maintenance.

How tall is the average telephone pole?

Typical utility poles measure 30 to 60 feet for poles in residential neighborhoods, and from 60 feet to over 120 feet along major highways.

What fluid goes in a Power-Pole?

Power-Pole has developed Green Marine hydraulic fluid to provide the performance of a petroleum product without the harmful effects. This ISO-32 fluid is ideal for use in Power-Pole systems, trim tabs, jack plates, tilt and trim rams, hatch lifters and more.

How do you bleed a Power-Pole?

Cycling the power pole up and down will bleed it. "Using the control raise and lower the Power-Pole several times to prime the system.

What wood is used for power lines?

For Tree Farmers, utility poles have the potential to provide an excellent return on investment. Southern yellow pines and Douglas fir are the most popular trees due to their size, but Northeastern red pine, Western red cedar and other softwoods that grow tall and straight are also used.

How much does the average wooden telephone pole weigh?

Wood poles

A standard American utility pole composed of wood is available in a variety of diameters and weights. Over time, however, 40-foot poles have become the accepted standard, and wooden poles of this length often weigh around 1,100 pounds.

Can you buy telephone pole?

Utility poles are available from 20' to 75' lengths. The Utility poles all have a 6” tip and very in bases depending on the length of the utility pole. Pilings are a grade nicer than utility poles and start at 10' lengths and also go to 75' lengths.