How much bleach does it take to shock a pool?

If you need to calculate how much bleach or Clorox you need to shock your pool, you will have to use 1/2 gallon of bleach per 10,000 gallons of water to raise the chlorine levels by 5 ppm.

How much bleach equals a bag of shock?

One pound of 65% Cal-Hypo is equivalent to 117 fluid ounces (0.91 gallons) of 8.25% bleach. One pound of non-chlorine shock (43% MPS) is "equivalent" to 36 fluid ounces (0.28 gallons) of 8.25% bleach, but non-chlorine shock is not the same as chlorine.

Is bleach and pool shock the same thing?

SKIMMER NOTES: No. Chlorine and shock are not the same thing. Shock has a more intense chemical strength than the traditional chlorine sanitizers, and it also differs in how you should apply it to your swimming pool.

How do you shock a pool with household bleach?

Now you can know the gallons of bleach you would need to shock your pool as follows: use 0.5 gallons of Clorox per 10K gallons of water to increase the level of chlorine by 5 ppm. If you want to raise the level of chlorine by 2.5 ppm, then you would need ¼ gallon of the product per 10K gallons of water.

What percent bleach is pool shock?

The general recommendation is to use 1 pound of cal hypo shock for every 10,000 gallons of pool water, and 10 ounces of sodium hypo with around 12.5% chlorine to sanitize your pool.

Can You Use Liquid Bleach To Shock a Green Pool ?

Can I put regular bleach in my pool?

Bleach contains about 5% to 6% sodium hypochlorite, which means roughly 95% of your jug of bleach won't do anything useful to clean your pool. Some bleach formulations may include colorings and fragrances, which can negatively affect the quality of your pool water.

Is pool shock stronger than bleach?

At a 12.5% concentrate, liquid pool shock is approximately 2x's stronger than Clorox bleach. The recommends 5 tablespoons of regular bleach per gallon of water to properly disinfect a surface. When using liquid pool shock, dilute it at a rate of 2.5 to 3 tablespoons per gallon of water.

Will bleach clear up a green pool?

Green algae, unlike its black counterpart, is a true algae; it isn't resistant to chlorine, so you can control it by shocking the pool. If you don't want to spend a lot of money on expensive pool chemicals, you can shock with household bleach.

Can I use Clorox bleach in my pool?

It is important to know what exactly bleach is before you put it in your pool. Household bleach, Clorox and liquid chlorine can all be used to sanitize a pool. They are all types of chlorine. Household bleaches such as Clorox usually contain about 5-6% available chlorine, about half that of pool liquid chlorine.

Can you put bleach in a vinyl pool?

High concentrations of chlorine (above 1.5 ppm) will attack the liner and bleach it, thus damaging it. Any level below this range will weaken its ability to kill off bacteria.

Can I use bleach instead of shock?

Using Bleach as a Shock

You need to use less of such products per volume than you do if you simply add chlorine, and if you opt for chlorine alone, you need more bleach than you do pool chlorine. Bleach contains the same chemical -- sodium hypochlorite -- as pool chlorine, but the concentrations are different.

How long after putting bleach in pool Can you swim?

Liquid chlorine — In general, it's a good idea to wait at least four hours after putting liquid chlorine in the pool. The size of your pool and the amount of chlorine added does play a factor in this, too. Once your levels reach 5 ppm or lower, you're ready to swim.

Which is stronger bleach or chlorine?

Answer: It is true that pool chlorine is stronger than bleach. For bleach and water to be the same strength as pool chlorine and water, you would have to adjust the ratio, increasing the bleach and reducing the water. But no matter which chlorine you use, make sure to test a small area before doing the job.

Can you mix bleach with pool shock?

It Should Not Be Done Together

This is because when you mix chlorine and algaecide together, it renders both of them useless. Hence, you should first shock the pool and wait for the chlorine levels to fall below 5 PPM.

How much shock do I need for a 10000 gallon pool?

One pound of shock treats up to 10,000 gallons of pool water. Also, keep the pool filter and pump running for at least 10 hours during and after you shock.

How often should I put bleach in my pool?

Once you've obtained a good reading, you can usually maintain your chlorine levels by adding chlorine tablets once a week. These dissolve more slowly and will keep your chlorine levels stable.

What can I use instead of pool shock?

Common unscented household bleach (sodium hypochlorite) works well to shock a pool.

Why is my pool still cloudy after shocking it?

But if the cloudy water persists long after you've shocked the pool, you're likely having an issue with water balance, circulation, or filtration. Heavy use of a calcium based pool shock (cal-hypo) may increase Calcium Hardness over a period of time, increasing your odds of cloudy water.

How much bleach do I put in a 20000 gallon pool?

This will give you an estimate of how much water your pool holds. Once you have this figure then the rule of thumb is you will need around ½ gallon of bleach for every 10,000 gallons of water to increase the chlorine level by 5 parts per million.

Will baking soda clear up cloudy pool?

Baking soda can work wonders in a pool. Baking soda can: Help to clear cloudy water and restore the sparkle. Spot-treat algae.

Is household bleach the same as pool chlorine?

They are identical in every way, with the exception of strength. Household bleach is usually a 6% concentration (although some of the cheaper stuff is 3%), while pool chlorine can typically be found in strength between 10% and 12%. All of this is sodium hypochlorite, and works the same in sanitizing your water.

Which is cheaper chlorine or bleach?

Bleach is also inexpensive in comparison to standard pool chlorine. As of 2017, a gallon of bleach can be purchased for $1 when bought in bulk. Pool chlorine is more expensive by comparison. If there's a disadvantage to bleach, it's that it's comparatively weak when matched against pool chlorine.

How much bleach do I add to my pool calculator?

If you need to calculate how much bleach or Clorox you need to shock your pool, you will have to use 1/2 gallon of bleach per 10,000 gallons of water to raise the chlorine levels by 5 ppm.