How do you replace a fence post without removing concrete?

The best way to replace a fence post without removing the concrete footing is by prying it out. You can do this with a long lever and fulcrum or a car jack. In either case, nail some wood to the post first to pry against and then get to work. Pry until the post releases from the concrete and comes all the way out.

Can you put a new post in old concrete?

Replace the Post

If your new post struggles to slide into the concrete foundation, you may need to sand it down a bit. However, you do not want to remove too much of the post's bottom as this will make it more vulnerable to breaking under pressure. Check to see that your new post is level and sits at the proper height.

How do you replace a fence post on an existing fence?

Can you reuse fence posts with concrete?

Posts with concrete at the base are the most difficult to remove and reuse because the concrete base is larger than the post, which makes pulling it up through the ground much harder.

How do you get a concrete post out of the ground?

It's probably 18-24" in the ground and set in concrete. If you do need to remove it, dig down one side of it with a narrow spade (or better still a trenching tool) and lever it into the hole you've just made - sufficient to loosen it enough to remove. It will be heavy - try to set up some form of lever to lift it out.

How to remove and replace a rotted fence post anchored in concrete

Does post buddy work?

Yes, Post Buddy will work on a round post, as long as your post is set in a concrete base. It's the concrete base which is important, as it provides a firm, below-ground anchor for our system. You will need to position the Post Buddys as close to directly opposite each other as possible when fixing a round post.

How do you replace a wooden post in concrete?

Can you reuse a concrete footing?

If the footings appear settled, cracked, tilted or heaved they should not be reused. The next consideration is the deck load each footing is supporting. If the size of the footings is known, then the new deck design must not overload any existing footing.

How do you fix a wobbly fence post?

How do you fix rotting wood post without replacing it?

Wood fillers are products such as Bondo and Minwax that are designed to be all-purpose fillers for gaps, holes, and rotted wood. Their application is simple, they cure quickly, and they're not supposed to shrink once dry.

How do you stabilize a rotting fence post?

If you have only a few rotted posts, consider stabilizing them with steel splints or braces. If the post in question isn't set in a concrete footing, E-Z Mender splints are the easiest, most effective hardware to apply. C are made for reinforcing 4 x 4 posts.

How do you break up thick concrete?

Start to break the concrete, starting six inches from the edge and working your way in. For slabs less than four inches thick, use a sledgehammer. For more than four inches thick, use a demolition hammer.

Is 2 feet deep enough for fence posts?

The minimum depth that you should dig your fence post holes for panel sections is 2 feet. A general formula is to dig the holes one-third to one-half of the post's aboveground height. The deeper you dig the holes, the more stability your fence has, but you must also purchase longer posts.

How many bags of quikrete do I need for a fence post?

1 – 4 bags of concrete per fence post are typically what's needed. This depends on the type of soil, fence design, height, post size and bag weight. In general the depth of the post's hole needs to be 1/3 to 1/2 of the above ground height of the post.

How many bags of concrete do you need for a fence post?

Most fence post holes will need between 1 - 4 bags of concrete to securely hold the post in place. The best way to determine the size of the hole is: Diameter of the hole is 3 times the width of the fence post. Depth of the hole is one-third to half the above ground height of the fence post.