How deep should a privacy fence post be?

Dig post hole so diameter of the hole is 3 times the width of the post (i.e., the hole for a 4” wood post should be about 12 inches wide). The depth of the hole should be 1/3-1/2 the post height above ground (i.e., a 6-foot tall fence would require a hole depth of at least 2 feet).
Takedown request   |   View complete answer on quikrete.com


How deep should an 8 foot post be in the ground?

For an average fence post, about 6 to 8 feet tall, prepare to dig a post hole about 2 feet deep. To install a fence post, you'll need a shovel or post digger, a 6-foot level, soil, and gravel or crushed stone.
Takedown request   |   View complete answer on thisoldhouse.com


Is 12 inches deep enough for fence post?

So, if you're planning on using a four-inch round or 4x4-inch square post, your post hole will need to be 12 inches in diameter. For our six-foot-high fence post, we would need a hole that's 36 inches deep and 12 inches in diameter. The depth of your post hole plays a key role in the strength of your posts.
Takedown request   |   View complete answer on hgtv.com


Should wood fence posts be set in concrete?

Concrete provides a strong foundation for wooden fence posts, but can rot them more quickly. Setting them in dirt, with or without gravel or crushed rock depending on your soil type, can help the posts last longer before going rotten. You can also use metal fence post anchors to prolong their life.
Takedown request   |   View complete answer on takeayard.com


Should you put gravel under fence post?

If a fence post fails without any sign of a pest infestation, it's likely that the failure was caused by moisture that rotted the wood over time. To help slow such deterioration, add pea gravel or crushed stone to the bottom of the posthole.
Takedown request   |   View complete answer on bobvila.com


How To Build A Fence: How Deep Should Fence Posts Be Set?



How long will a pressure treated post last in the ground?

A treated 4×4 will last 20 to 25 years in the ground if the conditions in the soil and climate are favorable. That number could increase to 40 to 75 years if you install the treated 4×4 in a cement ring rather than the soil.
Takedown request   |   View complete answer on thecoldwire.com


How deep should a 6 foot post be in the ground?

The depth of the hole should be 1/3-1/2 the post height above ground (i.e., a 6-foot tall fence would require a hole depth of at least 2 feet). Add about 6 inches of QUIKRETE All-Purpose Gravel into the bottom of the hole. Then compact and level the gravel using a post or 2x4.
Takedown request   |   View complete answer on quikrete.com


Can a fence post be 1 foot deep?

Especially since posts are responsible for supporting the rest of the fence, including panels and heavy gates, you must make sure that you buy a long enough post for your purposes and bury it deep enough. In most circumstances, a 1-foot hole will not be deep enough to provide proper support.
Takedown request   |   View complete answer on homeguides.sfgate.com


How many bags of quikrete do I need per fence post?

1 – 4 bags of concrete per fence post are typically what's needed. This depends on the type of soil, fence design, height, post size and bag weight. In general the depth of the post's hole needs to be 1/3 to 1/2 of the above ground height of the post.
Takedown request   |   View complete answer on gambrick.com


How many bags of concrete do you need for a fence post?

Most fence post holes will need between 1 - 4 bags of concrete to securely hold the post in place. The best way to determine the size of the hole is: Diameter of the hole is 3 times the width of the fence post. Depth of the hole is one-third to half the above ground height of the fence post.
Takedown request   |   View complete answer on everything-about-concrete.com


What size post do you use for an 8 foot fence?

A common rule of thumb, is to dig the hole 3 times as large as the post, and to a depth of 1/3-1/2 of the post height above ground. so for a 8' high fence, using 4x4 posts. dig the holes 12" in diameter, to a depth of 2 1/2 - 4'. Of course, that's assuming you're setting the posts in concrete.
Takedown request   |   View complete answer on diy.stackexchange.com


Is quikrete good for fence posts?

The best concrete mix for fence posts I've found is Quikrete Fast Setting Concrete Mix in a 50 lb bag. It's 4000 psi, easy to work with, sets up fast, and doesn't need to be mixed. Just pour it in the hole and soak with water.
Takedown request   |   View complete answer on gambrick.com


Is it better to pour concrete wet or dry?

Dry the ground out even more by throwing an inch of sand onto the ground. Not only will this absorb the water, but it will make it an ideal surface to pour concrete on as the sand holds up much better in colder weather.
Takedown request   |   View complete answer on hunker.com


What size post do you use for a 6 foot fence?

Post lengths for fences start at 8 or 10 feet for a 6-foot-tall fence. They are commonly four-by-fours, which measure approximately 3 1/2 by 3 1/2 inches, or six-by-sixes, at around 5 1/2 by 5 1/2 inches.
Takedown request   |   View complete answer on kingcats-fence.com


Is 3 feet deep enough for fence posts?

As a general rule of thumb one-third of your post should be underground, the other two-thirds above. Let's take a standard 6foot (72 inches) fence as an example. You will need a 9foot (108 Inches) post so that 3ft (35 inches) can be underground and 6ft can be above ground.
Takedown request   |   View complete answer on riverwoodlandscape.ca


Do fence post need to be below the frost line?

All fence posts should be cemented in the ground below frost level. Check your local frost level and dig deeper by at least 6".
Takedown request   |   View complete answer on hooverfence.com


How much gravel do I need for a fence post?

How much gravel do I put in the hole? You should put approximately 2" to 4" of gravel in the bottom of the hole making sure that the Post stands 6' 4" tall from the ground to the top of the post.
Takedown request   |   View complete answer on images.homedepot-static.com


What lasts longer cedar or pressure treated wood?

When it comes to comparing treated wood vs. cedar, pressure-treated wood is the sturdier and more weather-proof of the two. It's highly resistant to insect attack and rot, and special versions rated for “ground contact” can be buried in soil and will continue to shrug off decay for decades.
Takedown request   |   View complete answer on hgtv.com


Can pressure treated wood go directly on concrete?

So, can you put pressure treated wood directly on concrete? Yes, you can.
Takedown request   |   View complete answer on woodworkingclarity.com


How do I keep my post from rotting in the ground?

Placing a thick layer of loose gravel at the bottom of the post hole will allow groundwater to trickle through the rocks and down away from the base of the post. This will prevent the post from rotting by keeping it constantly dry. You can purchase gravel at a local hardware store or landscaping-supply business.
Takedown request   |   View complete answer on wikihow.com


Should I use concrete or cement for fence posts?

Concrete is the most secure material for setting fence posts, especially if you have sandy soil. Gravel may be okay with dense, clay-heavy soil, but in looser soil, concrete is the only thing that will truly keep your fence posts stuck in place.
Takedown request   |   View complete answer on fenceauthority.com
Previous question
Is the elephant's foot alive?