Can you put a hot tub on any deck?

A hot tub on a deck is entirely possible, and it is possible your deck is already equipped to handle one. A deck designed to hold at least 100 pounds per square foot will support nearly any type of hot tub.

Can a normal deck support a hot tub?

Yes, you can put a hot tub on a deck. Decks built ground level up to 2 feet off the ground can support up to 100 lbs per square foot; sufficient for most hot tubs. But decks 2 feet or higher will need added support. The added support posts should be no more than 30″ apart & ideally placed in poured concrete.

How do I know if I can put a hot tub on my deck?

As a general rule of thumb, if you have a deck that's raised only a couple feet or less, it can support about 100 pounds per square foot. So, if the spa is less than 100 pounds per square foot you likely have nothing to worry about.

What kind of deck can support a hot tub?

A solid, flat surface is required for a hot tub. A concrete slab is effective at supporting a hot tub. This must be installed along with the concrete deck footings of your deck. For most, a slab four inches thick should suffice, unless one decides to get a very large hot tub then something thicker should be poured.

How hard is it to put a hot tub on a deck?

If you already have a deck, it may not be strong enough to support the weight of a hot tub. Most decks are built with the intention of being able to support a number of people, some patio furniture and perhaps a BBQ or outdoor kitchen area - not a hot tub that can weigh several thousand pounds.

Can a Hot Tub Go on a Wooden Deck?

Will a hot tub ruin my deck?

Hot tub water can harm a wooden deck, so you need to be careful if you decide to put one on there. But all decks are exposed to wind, and in some cases hail and snow too. So as long as you used pressure-treated lumber, and especially if you applied a stain or sealer on it, it really should be fine.

Will my decking hold a lazy spa?

Can my deck hold a hot tub? If you're thinking of putting up an inflatable hot tub on your decking, have no fear! Wooden decking shouldn't have any issues holding a tub full of water and people, as long as it's close to the ground.

Can a wooden deck hold a hot tub?

A hot tub on a deck is entirely possible, and it is possible your deck is already equipped to handle one. A deck designed to hold at least 100 pounds per square foot will support nearly any type of hot tub.

How do I know how much weight my deck can hold?

If your deck is built to code, then it is designed to hold a minimum of 50 pounds per square foot, of which ⅘ of that total is the “live” load. Therefore, a deck of 120 square feet multiplied by 50 shows that your deck can hold 6000 pounds, including the structure.

How heavy is a full hot tub?

In general, a small two- or three-person hot tub generally weighs around 500 pounds empty and 3,000 pounds when filled with water. A six-person model typically weighs approximately 1,000 pounds empty or 6,000 pounds full.

Can my floor support a hot tub?

If you consider that spa measures approximately 60 square feet, then the floor must be able to support at least 100 pounds per square foot. Floors in most homes can handle 125 to 300 pounds psf.

What is the best base to put a hot tub on?

A concrete surface is an excellent base for your hot tub as this material is extremely sturdy and long-lasting. If you have an existing patio made of concrete bricks, make sure it's in good condition and is level (not angled for drainage). A customized poured concrete pad is an even better choice.

How close can you put a hot tub to your house?

The steam that comes from the water may seep into windows and water splashed from the tub may cause a slippery walkway. A few feet away from your home and a few feet away from your walkway is typically the ideal combination.

How do you build a deck to hold a hot tub?

What can I put my hot tub on?

For outside installation, it's recommended you place the spa on a level, 4-inch thick concrete slab. Other options include gravel, railroad ties, stepping or paving stones, and bricks. However, given the spa's size, weight, and need for a level foundation, a strong, solid base is much preferred.

Does a hot tub have to sit on concrete?

A hot tub does not have to sit on concrete and can be placed on any stable, level surface that will not become unstable due to moisture or weight. Those surfaces include wooden decks, paver stones, gravel beds, or spa pads.

Can I put a pool on my deck?

Building a deck to hold a pool takes a little extra planning. You can place a pool on a wooden deck if the construction takes into account several factors. Of course, pools are very heavy. And a lot of water will be splashed, poured and dripped on your wooded deck, potentially weakening it over time.

What is a floating deck?

A floating deck is a deck that isn't attached to a building and they “float” above the ground. Generally, floating decks are low to the ground and don't require handrails or even staircases. They are sometimes called “grade-level” or “freestanding” decks because they're built just above the ground level, or grade.

Can you put a hot tub on composite decking?

Hot tubs and composite decking (if done correctly) make the perfect match and together, are an excellent opportunity to upgrade your outdoor space. The contemporary look and finish, and high performance of composite decking offers the ideal solution that can complement a hot-tub installation perfectly.

How much weight can my patio hold?

A typical residential patio is 4″ thick with an average of 3000 pounds per square inch ratio. It is designed to carry more than the weight of two automobiles. The average compact car is about 3,000 to 3,500 lbs. A mid size car, van or light truck is about 5,000 to 7,000 lbs.

Can I put a spa on my balcony?

The average balcony cannot hold a full-sized hot tub. Balconies are typically designed to support between 50-100 pounds per square foot, whereas a fully loaded hot tub with water and people would likely exceed 100 pounds per square foot.

How much weight can a typical deck hold?

In short there's no one right answer to “how much can my deck hold?” However, one rule of thumb to keep in mind while answering the question is that the answer commonly is that if a deck is properly designed, it's built to hold 50 lbs. per square foot. It's possible that it could hold much more weight than 50 lbs.

How heavy is a full inflatable hot tub?

Based on an average of some of the most popular models, a filled inflatable hot tub weighs around 2,290 lbs (or 1,038.8kg). This includes the tub itself, and the water (filled to a recommended 80% capacity).

What are the rules for hot tubs?

Recommended guidelines suggest that you should use a hot tub for 15 to 30 minutes at a time with a maximum of 45 minutes at any one time. DO NOT EAT FOOD OR SMOKE IN THE TUB. DO NOT IMMERSE YOUR HEAD UNDERWATER. DO NOT PUT ANY WEIGHT ON THE PLASTIC LID AS IT MAY DAMAGE OR BREAK THE LID.