Can MTA be used for pulpotomy?

MTA may be used as an alternative pulpotomy agent in immature teeth with pulp exposure to stimulate pulp healing with dentin bridge formation and complete root formation. But, discoloration following MTA pulpotomy appears as a major clinical complication.

Why MTA is not used in pulpectomy?

So because of these proprieties, MTA was our choice of root canal filling in this case. However, in other way, it presents drawbacks discoloration potential, the difficulty to be used in obturation of curved root canals, the impossibility of retreatment, and the high cost.

What can I use for pulpotomy?

Mineral trioxide aggregate (MTA), Biodentine and ferric sulphate yielded good clinical results over time and might be safely used in the pulpotomies of primary molars. Among agents, MTA seemed to be the material of choice.

When MTA is used in pulpotomies it is known to induce?

MTA has demonstrated the ability to induce hard-tissue formation in pulpal tissues,51,53,56-59 and it promotes rapid cell growth in vitro. 60 Compared with calcium hydroxide, MTA has demonstrated a greater ability to main- tain the integrity of pulp tissue.

Can MTA be used for pulp capping?

MTA is a new and biocompatible biomaterial used for dental practice. It has been proved to be an excellent material for repairing of root perforations, apexification, root-end filling, repairing of root resorption and pulp capping.

MTA pulpotomy – Video abstract ID 134315

What is MTA pulpotomy?

MTA may be used as an alternative pulpotomy agent in immature teeth with pulp exposure to stimulate pulp healing with dentin bridge formation and complete root formation. But, discoloration following MTA pulpotomy appears as a major clinical complication.

Which is better MTA or calcium hydroxide?

MTA is more effective and superior comparing the Calcium Hydroxide as a direct pulp capping material, showed higher success rate with favorable outcomes in maintaining long term tooth vitality and easier to use in pulp capping. MTA is less toxic, less pulpal inflammation capping compared to Calcium Hydroxide.

Where is MTA used?

MTA is used for creating apical plugs during apexification, repairing root perforations during root canal therapy, treating internal root resorption, and pulp capping. The objective of this article is to investigate MTA features from a clinical point of view, even compared with other biomaterials.

Does MTA dissolve?

Because MTA is alkaline in nature, it might interact with acids or chemicals and could disintegrate.

What is MTA pulp therapy?

MTA was used as pulp-capping material after partial pulpotomy to preserve the vitality of the pulpal tissues in two cases. Follow-up examinations revealed that the treatment was successful in preserving pulpal vitality and continued development of the tooth.

Which material is used for pulpectomy?

Zinc oxide eugenol (ZOE) has traditionally been used as a root filling material in primary teeth pulpectomy.

Can IRM be used for pulpotomy?

Results. Among the 608 teeth (338 patients) treated in a single session with IRM full pulpotomy and stainless steel preformed crowns, 263 (143 patients) were evaluated after a median follow-up period of 24 months. Overall, 89% of the pulpotomies were effective, 7.6% were of uncertain outcome, and 3.4% were ineffective.

Can I use TheraCal for pulpotomy?

TheraCal PT is a biocompatible, dual-cured, resin-modified calcium silicate designed for pulpotomy treatment. TheraCal PT maintains tooth vitality by performing as a barrier and protectant of the dental pulpal complex.

Can we use MTA in primary teeth?

MTA as a pulpotomy agent has shown favorable results in case of primary molars. There is limited literature available regarding its use in primary incisors. However, the success of vital pulp therapy with MTA depends on proper case selection and technique of management of the tooth than the material itself.

Can we do obturation with MTA?

Consequently, MTA has been suggested and successfully used by eminent clinicians and researchers to obturate the entire canal.

Can Metapex be used in pulpectomy?

The use of Vitapex or Metapex is reportedly associated with high clinical and radiological success rates in the pulpectomy of primary teeth. However, even when the pulp tissue is debrided, pulp tissue remaining in the root canal will come into contact with the filling material.

Does MTA bond to tooth?

Nowadays, the material that offers the best sealing characteristic in the field of endodontic treatment is the mineral trioxide aggregate (MTA), nevertheless, this material necessities an adhesive bonding agent to perfectly join to the dental surface.

Does EDTA dissolve MTA?

17% carbonic acid was selected as one of the chemicals for disintegrating MTA and retrieve MTA. While 17% ethylenediaminetetraacetic acid (EDTA) can affect the setting and 10% citric acid are the common acids used for dissolving MTA.

What are the advantages of MTA?

MTA has the advantage of being less soluble than calcium hydroxide and offers an enhanced seal due to its setting expansion which hermetically seals the pulp space, preventing bacterial contamination from the outside.

Can MTA be mixed with saline?

The high sealing ability of MTA in combination with normal saline has been supported by all these studies. Also our study proved the superiority of the combination of MTA with normal saline compared to 5% CaCl₂ and KY Jelly.

How is MTA placed?

The MTA powder is mixed with sterile water, and the mixture is placed in contact with the exposure using a Dovgan carrier (Figure 2). Compress the mixture against the exposure site with a moist cotton pellet. Place a moist cotton pellet over the MTA and fill the rest of the cavity with a temporary filling material.

What is MTA sealer?

MTA Bioseal is an endodontic root canal sealer based on Mineral Trioxide Aggregate. It is a double paste component that allows complete filling of all root canals including accessory and lateral ones.

Is MTA a calcium silicate?

Mineral trioxide aggregate (MTA) is a calcium silicate-based cement (CSC) commonly used in endodontic procedures involving pulpal regeneration and hard tissue repair, such as pulp capping, pulpotomy, apexogenesis, apexification, perforation repair, and root-end filling.

Why do we use calcium hydroxide in direct pulp capping?

Calcium Hydroxide Cavity Liners

Calcium hydroxide cements are used for lining specific areas of deep cavities or for direct pulp capping. The antibacterial action of calcium hydroxide makes these cements useful in indirect pulp-capping procedures involving carious dentin.

Is Biodentine same as MTA?

Biodentine is comparatively a new biomaterial claimed to have properties comparable to mineral trioxide aggregate (MTA). Biodentine and MTA are effectively used for direct pulp capping (DPC), and they are capable of regenerating relatively damaged pulp and formation of hard dentine bridge.