Can I use bleach to shock my pool?

Calculate the amount of bleach you need based on the fact that 1 gallon will raise the free chlorine level of 30,000 gallons of water by 2 ppm. If you need to mildly shock a 30,000-gallon pool by raising the free chlorine concentration to 5 ppm, you need 2.5 gallons of bleach. To raise it to 10 ppm, you need 5 gallons.

Is it safe to shock a pool with bleach?

Bleach is safe and the only chemical you should be using in your pool unless cleaning pool tile with baking soda. So yes, you can use bleach to keep your pool water chemistry balanced.

Can you substitute bleach for pool shock?

6-8.5% for Clorox (bleach). Some Clorox products go as high as 8.5%. At a 12.5% concentrate, liquid pool shock is approximately 2x's stronger than Clorox bleach. The recommends 5 tablespoons of regular bleach per gallon of water to properly disinfect a surface.

Is bleach and pool shock the same thing?

SKIMMER NOTES: No. Chlorine and shock are not the same thing. Shock has a more intense chemical strength than the traditional chlorine sanitizers, and it also differs in how you should apply it to your swimming pool.

Can I use bleach in my pool instead of chlorine?

Household bleach, Clorox and liquid chlorine can all be used to sanitize a pool. They are all types of chlorine. Household bleaches such as Clorox usually contain about 5-6% available chlorine, about half that of pool liquid chlorine. Household bleaches often have unwanted fragrances and colors.

Using Clorox Bleach in Your Swimming Pool

How much bleach is needed to shock a pool?

If you need to calculate how much bleach or Clorox you need to shock your pool, you will have to use 1/2 gallon of bleach per 10,000 gallons of water to raise the chlorine levels by 5 ppm.

Can you use Clorox for pool shock?

Now you can know the gallons of bleach you would need to shock your pool as follows: use 0.5 gallons of Clorox per 10K gallons of water to increase the level of chlorine by 5 ppm. If you want to raise the level of chlorine by 2.5 ppm, then you would need ¼ gallon of the product per 10K gallons of water.

What can I use instead of pool shock?

Common unscented household bleach (sodium hypochlorite) works well to shock a pool.

Can you put bleach in a vinyl pool?

High concentrations of chlorine (above 1.5 ppm) will attack the liner and bleach it, thus damaging it. Any level below this range will weaken its ability to kill off bacteria.

Will bleach clear up a green pool?

Green algae, unlike its black counterpart, is a true algae; it isn't resistant to chlorine, so you can control it by shocking the pool. If you don't want to spend a lot of money on expensive pool chemicals, you can shock with household bleach.

How much bleach equals a bag of shock?

One pound of 65% Cal-Hypo is equivalent to 117 fluid ounces (0.91 gallons) of 8.25% bleach. One pound of non-chlorine shock (43% MPS) is "equivalent" to 36 fluid ounces (0.28 gallons) of 8.25% bleach, but non-chlorine shock is not the same as chlorine.

Is bleach the same as chlorine?

Chlorine is a natural element and an ingredient of bleach, while bleach is a solution and the product of combining chlorine and other chemicals. 2. Chlorine exists in nature, while bleach is a manufactured product.

Is Clorox bleach the same as pool chlorine?

In truth, bleach contains the same base chemical as pool chlorine. That chemical is, of course, chlorine, and the only major difference between the two products is the concentration strength. Pool chlorine typically contains some form of stabilizer, as well, though this is not a crucial factor.

How long after putting bleach in pool Can you swim?

Liquid chlorine — In general, it's a good idea to wait at least four hours after putting liquid chlorine in the pool. The size of your pool and the amount of chlorine added does play a factor in this, too. Once your levels reach 5 ppm or lower, you're ready to swim.

Which is stronger bleach or chlorine?

Answer: It is true that pool chlorine is stronger than bleach. For bleach and water to be the same strength as pool chlorine and water, you would have to adjust the ratio, increasing the bleach and reducing the water. But no matter which chlorine you use, make sure to test a small area before doing the job.

Can you use baking soda to shock a pool?

A rule of thumb is 1.5 lbs. of baking soda per 10,000 gallons of water will raise alkalinity by about 10 ppm. If your pool's pH tested below 7.2, add 3-4 pounds of baking soda. If you're new to adding pool chemicals, start by adding only one-half or three-fourths of the recommended amount.

Will baking soda clear a green pool?

Will baking soda clear a green pool? No. Baking soda will only raise your alkalinity and pH levels and this will not kill algae. Chlorine is what kills algae.

How much bleach equals a chlorine tablet?

Choose the sanitizer that best suits your individual preferences. *1 gallon of chlorinating liquid delivers the same amount of chlorine as 2 chlorinating tablets.

What is the difference between pool shock and chlorine?

Chlorine is a sanitizer, and (unless you use Baquacil products) is necessary for maintaining a clear and healthy pool. Shock is chlorine, in a high dose, meant to shock your pool and raise the chlorine level quickly.

Can I put vinegar in my swimming pool?

Just like you run vinegar through your coffee pot to get rid of calcium buildup, white vinegar can wipe away this eyesore in your pool. Mix a 50/50 solution of vinegar and water, dip a sponge or soft cloth into it, and scrub that residue away.

Do you run filter when shocking pool?

Run the filtration system

While shocking your pool will help kill any germs any algae, it won't actually get rid of them; for that, you need your filter. So be sure to run your pool filter for at least 24 hours.

Is bleach cheaper than shock?

It adds chlorine to your pool just like many other products, including bleach. The big advantage in bleach is there are no side affects.......the costs usually work out about the same with bleach usually being a little cheaper but not much.

How often should I put bleach in my pool?

Once you've obtained a good reading, you can usually maintain your chlorine levels by adding chlorine tablets once a week. These dissolve more slowly and will keep your chlorine levels stable.