Can I drive with EPS light on?

As long as you are not impeded by any negative side effects and you feel it is safe to steer your vehicle, you should be ok to continue driving your Hyundai until your appointment.

Can I still drive my car if the electric power steering goes out?

However, the good news is driving without electric power steering should not damage your car. If your power steering fails, you can still operate the steering wheel—at least enough to make it to the side of the road.

What happens when the EPS light comes on?

When the light is illuminated, it means that the EPS system is not functioning properly, and the vehicle should be serviced. Tip Like all warning lights, the EPS warning light briefly illuminates when the car is turned on. The light is only a problem if it stays lit when the engine is on.

How do I fix the EPS problem in my car?

This issue with the EPS light can also be caused if you have recently had to jump-start your car, or you've disconnected the battery. Occasionally, the problem can be fixed by simply turning your vehicle off and on again.

What causes EPS light?

The EPS light comes on when the computer detects an issue with the vehicle's electronic power steering system. If the computer detects an issue with the system it will set off the warning light to notify the driver of... Your vehicle is equipped with electronic power steering (EPS).

How to Identify EPS (Electronic Power Steering) Problems | Explained Difference EPS and HPS

Can EPS be repaired?

You can stop the engine and then start it again – the EPS will recover for a while, but this is temporary. The soonest possible diagnostics and repair in order to restore EPS normal function is highly recommended.

How much does it cost to fix electric power steering?

The average cost to repair a power steering pump is somewhere between $200 and $350. To replace the power steering pump with a new part, it will cost between $400 and $800 (depending on car model and what shop you take it to).

What causes EPS malfunction?

What Is EPS Malfunction And Why Does It Occur? When the steering wheel gets struck or disengages from the electric motor, EPS malfunctioning occurs. It usually happens because of the rust and water inside the arch or aging of the tightening rubbers.

How do I reset my EPS light?

You can turn the steering wheel 45 degrees to the left from a straight position. Then turn the ignition to ON. The EPS light should come on for 4 seconds and then go off. Immediately, when the EPS light comes off, return to the straight position.

What causes electric power steering to go out?

Today's electronic power steering systems may fail due to issues with the mounted electric motor. In particular, excessive heat on the motor is likely to cause the failure modes. Infiltration of the system environment by water, dirt, or other contaminants will also likely lead to EPS failure.

How do you reset the power steering assist fault?

The easiest way to reset that alert is to restart your car. Switch your entire car on and off. This will reset all the electrical components in your car. Repeat the process 2 or 3 times this will get rid of the power steering assist fault warning.

How long can I go without power steering?

You may drive with a low-power steering fluid and have little to no effects before refilling it. But driving without power steering for more than five minutes will damage the seals and gaskets on the pump. It'll also cause premature wear on the pump.

How do you know if your electric power steering is bad?

What does EPS on a car mean?

Electric power steering (EPS) is a key technology for highly automated driving. The Bosch EPS variants meet the requirements for small, mid-range, sports cars as well as light commercial vehicles. The EPS has an electric motor which controls the vehicle steering.

How do I reset my electric power steering pump?

If it is an electronic system, there is a chance it can be “reset”. Pull over as soon as possible and shut down the engine and restart it. If the warning light does not go out you will need to take the vehicle to your dealer or authorized repair facility.

What happens if electric power steering fails?

When that happens, your car's steering system will revert to manual operation (i.e., your muscles do all the work). As a result, the steering wheel will become very difficult to turn. Electric power steering can stop working suddenly and render the vehicle very difficult to drive as well.

Does Electronic power steering use fluid?

First, an electric system doesn't draw power from the engine since it's powered by the car's electrical system. There's also no need for a hydraulic pump, lines, or power steering fluid either, so you can say goodbye to any potentially leaky messes.

How much does a power steering module cost?

Power steering pumps are essential to the operation of the car cars with power steering. The job can be costly: between $100-$200 for a new power steering pump if you DIY and around $500 to get it done by a mechanic. That said, it is not nearly as expensive as replacing your vehicle.

How do you diagnose EPS?

The main indication you'll get if there is a malfunction with the electric power steering system is that the EPS light will illuminate on the dashboard. Specifically, the warning light will come on when the EPS system is off.

What happens if your power steering pump goes out while driving?

This could be accompanied by a stiff wheel that is harder to turn at times or is slow to respond when you begin a turn. A bad power steering pump may even cause your vehicle to emit a squealing sound when you turn the key in the ignition.

Where is the EPS steering sensor located?

EPS is a relatively simple system. The steering shaft torque sensor, located in a section of torsion bar in between the steering input and output shafts, is the PSCM's main input for determining steering direction and the amount of assist needed.

How much does it cost to replace a steering angle sensor?

The average steering angle sensor replacement cost is between $150 and $500, depending on the car model and labor costs. The steering angle sensor costs $120 – $250, and the labor costs averaging at $80 – $250.

How do I know if my steering sensor is bad?

Common signs include the Traction Control Light coming on, steering wheel feeling loose, and the car driving differently after a front end alignment.

Will disconnecting the battery reset the steering angle sensor?

The most common one will be loss of electrical power to the steering angle sensor due to disconnecting the battery for some unrelated purpose (or the battery going flat). If any of the following occur, the system will need to be reset.