Should I replace the thermostat when replacing water pump?

The answer is absolutely because the thermostat itself can be damaged if there is an episode of overheating and, of course, a water pump failure is often associated with overheating.
Takedown request   |   View complete answer on yourmechanic.com


When replacing a water pump What else should you replace?

When changing a water pump, replace all old gaskets and seals with new ones. If your new pump comes with a seal, make sure it's in impeccable condition before installing it. (Some seals are so thin you could easily damage them when you rip off the packaging.)
Takedown request   |   View complete answer on gatestechzone.com


What do you need when replacing a water pump?

TO CHANGE YOUR WATER PUMP YOU WILL NEED:
  1. Sockets and wrenches.
  2. Screwdriver.
  3. Pliers.
  4. Drain pan.
  5. Rags.
  6. Gasket sealer.
  7. Antifreeze.
Takedown request   |   View complete answer on napacanada.com


How do I know if I need a water pump or thermostat?

When you see any of the following signs, it is an indication that you have a water pump or thermostat.
  1. Engine Overheating.
  2. Temperature gauge fluctuations.
  3. Coolant leaks from the front of your car.
  4. Steam coming from the front of your car.
  5. Nosey or loosen water pump pulley.
  6. Coolant leaks around the thermostat housing.
Takedown request   |   View complete answer on rxmechanic.com


What are the symptoms of a bad thermostat?

Thermostat failure symptoms that you should know
  • High temperature readings. The main symptoms of a failing thermostat are related to engine overheating. ...
  • Erratic changes in temperature. ...
  • Leaking coolant. ...
  • Increased fuel consumption. ...
  • Unusual noises.
Takedown request   |   View complete answer on idolz.com


Overheating After Replacing Radiator, Pump, Thermostat? Burp Coolant to Remove Air Pockets!



How do you tell if the thermostat is bad in a car?

Signs My Car's Thermostat Is Going Bad or Has Failed Completely
  1. Odd Temperature Gauge Readings. Your temperature gauge should register cold when you first start your car and slowly build up to normal as the engine warms up. ...
  2. Air Temperature Changes. ...
  3. Coolant Leaks. ...
  4. Strange Sounds. ...
  5. Heater Problems.
Takedown request   |   View complete answer on accurateauto.com


Do you have to drain the coolant when changing a water pump?

It's a job that could take several hours, depending on what you drive. The first steps in removing any water pump are to let the engine cool off completely, and then drain the cooling system by either opening the radiator petcock or disconnecting the bottom radiator hose.
Takedown request   |   View complete answer on popularmechanics.com


How much does it cost to replace a water pump and thermostat?

The average water pump replacement cost is $550, with prices ranging from $461 to $638 in the US in 2020. But typically depends on the type of vehicle you drive and the auto repair shop you take it to. Labor costs are between $256 and $324 while parts cost between $205 and $314.
Takedown request   |   View complete answer on sunwesttrans.com


How many hours does it take to replace a water pump?

Fixing a broken water pump can take anywhere from two hours to most of a day. A simple replacement should take around two hours, but more complicated work trying to fix a water pump (which will save you money on parts) can take four or more hours.
Takedown request   |   View complete answer on getjerry.com


Can a bad thermostat cause a water pump to fail?

Answer: If the temperature gauge indicates the engine is overheating, the water pump bearing may be faulty and not allowing coolant to circulate properly. Another possibility is the thermostat is not functioning right. Depending on your particular model, you can try to listen to the pump with a length of hose.
Takedown request   |   View complete answer on axleaddict.com


Why is my car overheating with a new water pump?

If it gets hot at all times, then it may have a clogged radiator, or more commonly a leaking head gasket. I would perform a block test prior to changing anything else. If that fails the test, then the engine will need to be disassembled and repaired. If it passes, then it may need a radiator.
Takedown request   |   View complete answer on yourmechanic.com


How often should a water pump be replaced?

Typically, the recommended interval for replacing the water pump is every 60,000 to 100,000 miles, depending on various factors, such as the car model, road and weather conditions, and driving behavior. Therefore, if you plan to invest in a used car, ensure you verify whether the seller replaced the water pump.
Takedown request   |   View complete answer on mingsautorepair.com


How long should a water pump last?

The average lifespan of a water pump is similar to the lifespan of a timing belt. They usually last 60,000 to 90,000 miles with the proper care. However, some cheaper water pumps may begin leaking at as low as 30,000 miles.
Takedown request   |   View complete answer on wrench.com


Can I replace a water pump myself?

A specialist workshop usually estimates a good three hours of work for changing a water pump. However, if you do this work yourself, the only costs incurred are those for a new water pump. These are usually between 50 and 500 pounds.
Takedown request   |   View complete answer on autopartspro.co.uk


What makes a water pump go bad?

The most common cause of water pump failure is simply from age and wear of its electric motor. Over time, most parts in a car or truck, auxiliary pumps included, start to break down due to constant wear and tear.
Takedown request   |   View complete answer on idolz.com


What does it sound like when your water pump is going out?

If you hear a high-pitched, whining sound that increases as you accelerate – it could indicate a faulty water pump. These sounds are caused by a loose belt and the belt becomes loose when the pulley is loose or the bearings are wearing out.
Takedown request   |   View complete answer on usa-autotransport.com


How long does it take to change a water pump and timing belt?

Changing a timing belt and water pump can take anywhere from 1-3 hours depending on your skill level, so make sure you have the time and space to complete the job. Do the following before you start: Jack up the front of the car so you can access the undercarriage beneath the engine.
Takedown request   |   View complete answer on holtsauto.com


How long does it take to change a water pump on a car?

Replacing a water pump can be a steady half-day's work. A simple and straightforward switch might only take 2 hours, but some of the more complicated could take even the most competent mechanic a full day. We'd suggest between 2 and 4 hours for the majority.
Takedown request   |   View complete answer on fixter.co.uk


How do I know if I need a new thermostat?

Signs You Need a New Thermostat
  1. Heating or cooling system will not turn off or on.
  2. The temperature reading is incorrect.
  3. Recent spike in your energy bill.
  4. Frequent temperature fluctuations.
  5. Thermostat is 10 years old or older.
Takedown request   |   View complete answer on icebergheatandair.com


When should I replace my thermostat?

9 Signs It's Time to Replace Your Thermostat
  • Your Thermostat Is Analog. ...
  • Your Thermostat Isn't Programmable. ...
  • Your Thermostat Is Older than Ten Years. ...
  • Your HVAC Turns On and Off. ...
  • Your Energy Bills Are Unusually High. ...
  • Your Thermostat Gives Faulty Readings. ...
  • Your Thermostat Doesn't Respond to Settings Changes.
Takedown request   |   View complete answer on rinaldis.com


When should I replace my car thermostat?

However, most car experts recommend car thermostat replacement after 10 years. However, this is an optimistic number. Thermostats are more likely to stop working much earlier than a decade. Some factors that induce an early thermostat failure include harsh weather, rough driving, bad engine or thermostat parts.
Takedown request   |   View complete answer on dubizzle.com