How do you clean a disgusting bathtub?

Sprinkle baking soda on all tub surfaces. For extra-dirty tubs, use tub-and-tile cleaner instead. Fill your bucket with a half-gallon of hot water and two tablespoons of dish soap. Dip a scrub sponge or a stiff nylon brush into the bucket, and scrub all bathtub surfaces.

How do I get my dirty bathtub white again?

Make a bathtub cleaner paste of one part hydrogen peroxide to two parts baking soda (or cream of tartar). Rub the paste on the stain and let stand for 30 minutes to one hour, then wipe and rinse. If necessary, repeat until the stain is gone.

How do you make an old bathtub look new?

What causes brown stains in bathtub?

These stains are caused by iron content in the hard water; the iron rusts, which is why the color looks rusty. You can also typically be clean these stains away, perhaps with the help of vinegar (another possible reason for rusty stains is that your water pipes are rusting).

How do I get my yellow tub white again?

White vinegar

However, a simple mixture of two parts white vinegar and two part water is all that's needed to remove the discoloration. Mix them in equal volume and pour the mixture into the bathtub. Brush the mixture over the surface gently, then rinse thoroughly.

HOW TO CLEAN A MOLDY SHOWER (super satisfying clean with me!)

Can bleach damage a bathtub?

Back to the question, “can bleach damage a bathtub?” Yes, it can. Bleach can add stains to your bathtub is misused. Remember, it is a massive chemical that, if not used correctly, can cause more harm than good.

Does Magic Eraser work on bathtubs?

Like magic, the Magic Eraser will start powering through tough grime in just a few swipes. Before you know it, your clean bathtub with shine like the top of Mr. Clean's head! And remember, you can also use Magic Eraser to clean other surfaces too.

How do you get stains out of an old porcelain tub?

Fill a bucket with warm water and add ammonia and baking soda to the liquid. Soak a cloth or sponge in the mixture and use it to scrub the tub — focusing especially on stained spots. Keep dipping the sponge, scrubbing and repeating until the tub is clean.

How do you clean a very dirty acrylic tub?

Does OxiClean clean bathtub?

OxiClean can melt away soap scum, slimy bacteria, and mildew. Make a soaking solution of OxiClean and water (again, half a cup of OxiClean per gallon of water), let your liner soak for about 15 minutes, and scrub any stubborn areas by rubbing the liner against itself.

Do you have to rinse after using Magic Eraser?

Rinse off the eraser after use. This will remove the dirt and debris and extend the life of your eraser. Test in an inconspicuous place if you're unsure. Don't use them on your skin.

Why should you put dawn in your bathtub at night?

That's right: Grab your dish soap and a broom, and you might be as pleasantly surprised as we were to learn that Dawn is apparently just as effective at banishing bathtub scum as it is at removing all that grime and grease from your dishes and pans. Plus, this technique is equal parts simple and fast!

Can you mix baking soda and vinegar?

Here are some recipes to try. Freshen your sink by mixing one part of baking soda with two parts of vinegar. This mixture unlocks an effervescent fizz of carbon dioxide that cleans and freshen drains.

How do you clean a bathtub with vinegar and Dawn?

Why do bathtubs turn yellow?

Fiberglass bathtubs may start to turn a yellowish color as a result of soap scum or hard water. These stains can be very difficult to remove. However, a mixture of cream of tartar and hydrogen peroxide will easily remove any stain and restore the tub to its original white color.

How do you remove yellow stains from porcelain tub?

If you have a porcelain tub, pour a little bit of Ajax or Comet directly onto the bathtub stain (enough to cover it completely). Add a little bit of water and scrub using the abrasive side of a sponge. If you rinse the affected area and you still see a stain, use a pumice stone to lift the remainder of the stain.

How do I get my tub white again Reddit?

i'd dry the tub, coat a layer of that on the stains and let it sit over night. then i'd throw some drain cleaner powder on it, mix and sit. after a few treatments, it's much better. it's almost like a teeth whitening program.

How do you get brown stains out of a porcelain tub?

Salt and lemon juice work particularly very well on rust stains on enamel or porcelain tubs. Simply pour salt on the stained areas and juice lemon on it. Let it sit for about 5 minutes and then scrub gently with a soft sponge. You can also scrub using a slice of lemon.

Where should you not use Magic Eraser?

When should you throw away Magic Eraser?

Once you're done using the eraser, wring it dry if it's still wet. You may also want to leave it out somewhere to air dry. Most magic erasers can be used dozens of times before needing to be replaced. You'll generally know when your eraser needs to replaced because it will begin to crumble and fall apart.

Why do magic erasers work so well?

It works because when melamine resin cures into foam, its microstructure becomes almost as hard as glass – causing it to act like super-fine sandpaper on stains. The abrasive foam loosens up dirt and grime, and the open microstructure of the foam sucks it in and traps it there. Neat, right?

Can you mix OxiClean and Dawn dish soap?

probably at least a cup of the Oxy Clean and Biz, ½ - ¾ cup of Cascade and ⅓ cup of Dawn. if you are using a larger container, use more soap. then, mix it all up. let all the soap crystals dissolve in the warm water.